Configuring CoPP
Procedure
-
Configure the default CoPP policy, edit an existing policy, or create a policy with the command
.copp-policy
-
Add, edit, or remove classes in the policy with the command
class
. -
If the policy is not the active policy on the switch, apply it with the command
. (Changes made to an active policy take effect immediately and do not need to be applied.)apply copp-policy
-
Review the CoPP policy configuration settings with the command
.show copp-policy
Example
This example creates the following configuration:
- Defines a new policy named My_CoppPolicy.
- Adds two classes to the policy.
- Activates the policy.
Displays policy configuration settings.
switch(config)# copp-policy My_CoppPolicy switch(config-copp)# class bgp-ipv4 priority 6 rate 5000 burst 60 switch(config-copp)# class ospf-multicast priority 2 rate 2000 switch(config-copp)# exit switch(config)# apply copp-policy My_CoppPolicy switch(config)# exit switch# show copp-policy My_CoppPolicy class drop priority rate kbps burst kB min-max pps --------------------- ---- -------- --------- -------- ----------------- bgp-ipv4 6 5000 60 412-9765 ospf-multicast 2 2000 25 165-3906 default 1 6000 70 494-11719