show module

Syntax

show module [<SLOT-ID>] [vsx-peer]

Description

Shows information about installed line modules and management modules.

Command context

Operator (>) or Manager (#)

Parameters

<SLOT-ID>

Specifies the member and slot numbers in format member/slot. For example, to show the module in member 1, slot 3, enter 1/3.

[vsx-peer]

Shows the output from the VSX peer switch. If the switches do not have the VSX configuration or the ISL is down, the output from the VSX peer switch is not displayed. This parameter is available on switches that support VSX.

Authority

Operators or Administrators or local user group members with execution rights for this command. Operators can execute this command from the operator context (>) only.

Usage

Identifies and shows status information about the line modules and management modules that are installed in the switch.

If you use the <SLOT-ID> parameter to specify a slot that does not have a line module installed, a message similar to the following example is displayed:

Module 1/4 is not physically present.

To show the configuration information—if any—associated with that line module slot, use the show running-configuration command.

Status is one of the following values:

Active

This module is the active management module.

Standby

This module is the standby management module.

Deinitializing

The module is being deinitialized.

Diagnostic

The module is in a state used for troubleshooting.

Down

The module is physically present but is powered down.

Empty

The module hardware is not installed in the chassis.

Failed

The module has experienced an error and failed.

Failover

This module is a fabric module or a line module, and it is in the process of connecting to the new active management module during a management module failover event.

Initializing

The module is being initialized.

Present

The module hardware is installed in the chassis.

Ready

The module is available for use.

Updating

A firmware update is being applied to the module.

Examples

Showing all installed modules (Aruba 6300 switch):

switch(config)# show module

Management Modules
==================

     Product                                        Serial
Name Number  Description                            Number     Status
---- ------- -------------------------------------- ---------- ----------------
1/1  JL659A  6300M 48SR5 CL6 PoE 4SFP56 Swch        ID9ZKHN090 Active (local)


Line Modules
============

     Product                                        Serial
Name Number  Description                            Number     Status
---- ------- -------------------------------------- ---------- ----------------
1/1  JL659A  6300M 48SR5 CL6 PoE 4SFP56 Swch        ID9ZKHN090 Ready

Showing a line module (Aruba 6400 switch):

switch# show module 1/3

Line module 1/3 is ready
 Admin state: Up
 Description: 6400 24p 10GT 4SFP56 Mod
 Full Description: 6400 24-port 10GBASE-T and 4-port SFP56 Module
 Serial number: SG9ZKMS045
 Product number: R0X42A
 Power priority: 128

Showing a slot that does not contain a line module:

switch(config)# show module 1/3
Module 1/3 is not physically present