A switch installed as described in its hardware installation guide.
A computer with terminal emulation software.
A JL448A Aruba X2 C2 RJ45 to DB9 console cable. (6400 only), or a USB-C cable (6300/6400).
Procedure
Connect the console port on the switch to the serial port on the computer using a console cable, or connect the USB-C port on the switch to the USB-C port on the computer using a USB-C cable.
Start the terminal emulation software on the computer and configure a new session with the following settings:
Speed: 115200 bps
Data bits: 8
Stop bits: 1
Parity: None
Flow control: None
Start the terminal emulation session.
Press
Enter once. If the connection is successful, you are prompted to login.