Adding and deleting an SNMP trap receiver

You can add trap receivers that can receive SNMPv1, SNMPv2c, and SNMPv3 traps or SNMPv2c and SNMPv3 inform messages.

Procedure

To add an SNMP trap receiver:
1. In the navigation pane, expand System, and select SNMP.
  The SNMP page is displayed.
2. In the Trap Receivers panel, click Add.
  The Add Trap Host dialog box is displayed.
3. Configure the following parameters:
  - Host: A valid IPv4 or IPv6 address of the SNMP host.
  - Type: The type of SNMP message, trap or inform.
  - Version: The SNMP version, v1, v2c, or v3.
  - User ID: The user ID for authentication. The user ID is required only if the SNMP version is v3.
  - Community: The community name available in the switch. The default community name is public. The community name is not required when the SNMP version is v3.
  - Port: The SNMP port on which the host listens for the trap requests. The default port number is 162.
  - VRF: The VRF available on the switch.
4. Click Add Host.
To delete an SNMP trap receiver:
1. In the Trap Receivers panel, select the trap receiver that you want to delete, and click Delete.
  A confirmation message is displayed.
2. Click Delete Host.