AOS-CX 10.07 Command-Line Interface Guide (6300, 6400 Switch Series)

Initial Configuration

Perform the initial configuration of a factory default switch

Initial config using ZTP

Initial config using the Aruba CX mobile app

Initial config using the CLI

Interface Configuration

Configure a layer 2 or layer 3 interface

Configuring a layer 2 interface

Configuring a layer 3 interface

List of interface commands


VLANs enable the grouping of users by logical function instead of physical location.

VLAN interfaces

Configuring VLANs

List of VLAN commands

Source Interface Selection

Unique identification of the software application on the server site

Source interface selection

List of Source interface selection commands

Device Discovery and Configuration

The switch supports automatic discovery and configuration of other devices on the network.

Device profiles


Cisco Discovery Protocol (CDP)

About this Document

Applicable products, versions, ports and interfaces

The HPE Movement Towards Inclusive Terminology

Hover over tile to read more

As part of advancing HPE's commitment to racial justice, we are taking a much-needed step in overhauling HPE engineering terminology to reflect our belief system of diversity and inclusion. Some legacy products and publications may continue to include terminology that seemingly evokes bias against specific groups of people. Such content is not representative of our HPE culture and these samples will be archived as and when the related products reach end of life.

What's New

Learn more about the new features and enhancements introduced in this release!

AOS-CX 10.07 Command-Line Interface Guide Online Help