Configuring RPF override

Configure Reverse Path Forward (RPF) override to allow the override of the normal RPF lookup mechanism, indicating to the router that it may accept multicast traffic on an interface other than the one that would normally be selected by the RPF lookup mechanism.

RPF checking ensures that multicast traffic received arrived on the expected router interface before it is considered for further processing. If the RPF check fails for a multicast packet, the packet is discarded.

RPF override entry gets precedence over routes learned from routing protocols or static routes. It must also be noted that PIM will not switch to an alternate path if the configured RPF neighbor is not reachable.


You must be in the PIM configuration context, as indicated by the switch(config-pim)# prompt for IPv4 or the switch(config-pim6)# prompt for IPv6.


Add, edit, or delete RPF overrides using the following command.


For IPv4 configurations:

switch(config)# router pim switch(config-pim)# rpf-override

For IPv6 configurations:

switch(config)# router pim6 switch(config-pim6)# rpf-override 50::4/24 40::1