AOS-CX 10.07 Quality of Service Guide Help Center
Configuring egress queue shaping
This example shows how to apply egress queue shaping to an interface. First, a schedule profile is created that has per-queue bandwidth limits set on all queues with strict as the scheduling algorithm. Next, this profile is applied to an interface or LAG.
On the 6400 Switch Series, interface identification differs.
The following example creates a schedule profile named EQSExample, which services all seven queues using strict priority. This profile configures queues 1, 4, and 7 with a bandwidth limit of 10 Gbps, 20 Gbps, and 30 Gbps respectively. The profile is then applied to interface 1/1/1.
switch(config)# qos schedule-profile EQSExample
switch(config-schedule)# strict queue 0
switch(config-schedule)# strict queue 1 max-bandwidth 10000000
switch(config-schedule)# strict queue 2
switch(config-schedule)# strict queue 3
switch(config-schedule)# strict queue 4 max-bandwidth 20000000
switch(config-schedule)# strict queue 5
switch(config-schedule)# strict queue 6
switch(config-schedule)# strict queue 7 max-bandwidth 30000000
switch(config-schedule)# exit
switch(config)# interface 1/1/1
switch(config-if)# apply qos schedule-profile EQSExample
