In-System Programming events
The following are the events related to in-system programming.
Event ID: 7200
Message |
Internal fatal error at <file>:<line> |
Category |
In-System Programming |
Severity |
Error |
Description |
ISP internal fatal error |
Event ID: 7210
Message |
Non-failsafe update needed for <devspec>. Please run the allow-unsafe-updates command |
Category |
In-System Programming |
Severity |
Error |
Description |
A non-failsafe device update is needed, but the allow-unsafe-updates command has not yet been run |
Event ID: 7211
Message |
Do not interrupt non-failsafe update for <devspec> |
Category |
In-System Programming |
Severity |
Error |
Description |
A non-failsafe device update is about to start, so do not interrupt it |
Event ID: 7212
Message |
Starting update for <devspec> from version <fromver> to version <tover> |
Category |
In-System Programming |
Severity |
Information |
Description |
A device update is about to start |
Event ID: 7213
Message |
Update successful for <devspec> from version <fromver> to version <tover> |
Category |
In-System Programming |
Severity |
Information |
Description |
A device update was successful or in some cases was successfully arranged to be performed later |
Event ID: 7214 (Severity: Critical)
Message |
Update failed for <devspec> |
Category |
In-System Programming |
Severity |
Critical |
Description |
A device update failed |
Event ID: 7215
Message |
Deferred update for <devspec> will be performed after an automatic module reset |
Category |
In-System Programming |
Severity |
Information |
Description |
A device update was postponed until after an automatic reset of its module |
Event ID: 7216
Message |
Approximately <time> minute(s) remaining to update <numdevs> device(s) on <modspec> |
Category |
In-System Programming |
Severity |
Information |
Description |
Indicates the approximate remaining update time for a module |
Event ID: 7217
Message |
Insufficient redundant power is available to update <devspec> |
Category |
In-System Programming |
Severity |
Information |
Description |
Unable to update non-redundant power supply |
Event ID: 7218
Message |
Programmable device updates are pending that require a power cycle. Wait for all fabric and line modules to be ready, then power the system off and back on again |
Category |
In-System Programming |
Severity |
Information |
Description |
ISP needs the chassis power-cycled manually when it cannot be done automatically |
Event ID: 7219 (Severity: Critical)
Message |
Failed to write-protect <devspec> (pass <pass>) |
Category |
In-System Programming |
Severity |
Critical |
Description |
Failed to write-protect a module or device |