apflash all|{ap-group <group>}|{ap-name <name>}|{ip-addr <ipaddr>}|{wired-mac <macaddr>} global|local [backup-partition] [server <ipaddr>]
Description
This command reflashes the specified AP.
Syntax
|
Parameter |
Description |
|---|---|
|
all |
Reflash all connected APs. |
|
ap-group |
Reflash the APs in the specified AP group. |
|
ap-name |
Reflash the AP with the specified name. |
|
ip-addr |
Reflash the AP at the specified IP address. |
|
wired-mac |
Reflash the AP at the specified MAC address. |
|
global |
Reflash APs on all switches |
|
local |
Reflash APs registered on this controller only (default) |
|
backup-partition |
Reflash partition two. (For AP80M, RAP-5, RAP-2WG only) |
|
server |
IP address of the FTP server. |
Usage Guidelines
This command directs an AP to download its image from the controller. You should not normally need to run this command, since APs automatically download their images from a controller during bootup.
Example
The following command reflashes a specific AP:
(host) (config) #apflash ap-name Building3-Lobby
Command History
|
Version |
Description |
|---|---|
|
ArubaOS 3.0 |
Command Introduced |
|
ArubaOS 6.0 |
The global and local parameters were introduced. |
Command Information
|
Platforms |
Licensing |
Command Mode |
|---|---|---|
|
All platforms |
Base operating system |
Enable and Config modes on master controllers |
Note:this release has not been updated since the release of the pdf