You are here: Home > CLI Commands > Just_CLI_Topics > ap debug client-trace stop

ap debug client-trace stop

ap debug client-trace stop

{ap-name <ap-name>}|{ip-addr <ip>}|{ip6-addr <ip6>}

Description

Use this command to stop tracing management packets from a client MACMedia Access Control. A MAC address is a unique identifier assigned to network interfaces for communications on a network. address.

Syntax

Parameter

Description

ap-name <ap-name>

Name of the AP.

ip-addr <ip-addr>

IPv4 address of the AP.

ip6-addr <ip6-addr>

IPv6 address of the AP.

Usage Guidelines

This command should only be used under the guidance of Aruba technical support.

Related Commands

Command

Description

ap debug client-trace start

Use this command to trace management packets from a client MACMedia Access Control. A MAC address is a unique identifier assigned to network interfaces for communications on a network. address.

show ap debug client-trace

Use this command to show counts of different types of management data frames traced from a client MACMedia Access Control. A MAC address is a unique identifier assigned to network interfaces for communications on a network. address.

Command History

Release

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

License

Command Mode

Available on all platforms

Base operating system.

Enable mode on Mobility Master.

/*]]>*/