You are here: Home > CLI Commands > Just_CLI_Topics > ap debug radio-registers dump

ap debug radio-registers dump

ap debug radio-registers dump [[filename <filename> {all|interrupt|qcu |radio}]ap-name <name>|ip-addr <ip-addr>|ip6-addr <ip6-addr>]

Description

This command allows you to collect all or specific radio register information into a separate file.

Syntax

Parameter

Description

ap-name

Name of the access point.

filename

Name of file where information is collected.

all

All registers interrupted.

interrupt

Interrupt related registers.

qcu

Collect QCU information.

radio

Radio ID (0 or 1).

ip-addr

Collect radio register information for this specific AP radio.

ip6-addr

Collect radio register information for the AP assigned to this ipv6 address.

Usage Guidelines

This command collects specified radio-register information for debugging purposes, dumps the registers into a local file, and will automatically transfer the file to the dump-server that is configured in ap-system-profile.

Example

The following command collects all radio registers from myap1 into a file called myradioregfile:

(host) [mynode] #ap debug radio-registers dump ap-name myap1 filename myradioregfile all

Command History

Release

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

License

Command Mode

802.11n802.11n is a wireless networking standard to improve network throughput over the two previous standards, 802.11a and 802.11g. With 802.11n, there will be a significant increase in the maximum raw data rate from 54 Mbps to 600 Mbps with the use of four spatial streams at a channel width of 40 MHz.-capable APs

Base operating system.

Enable mode on Mobility Master.

/*]]>*/