You are here: Home > CLI Commands > Just_CLI_Topics > ap debug stm-trace category

ap debug stm-trace

ap debug stm-trace category

[ip-addr <ip-addr> | loglevel | mac <mac>]

Description

This command enables / disables stm-trace categories.

Syntax

Parameter

Description

category

The trace category to be enabled or disbaled.

all - Traces all categories

amon - Traces in the category of AMONAdvanced Monitoring. AMON is used in Aruba WLAN deployments for improved network management, monitoring and diagnostic capabilities.

auth - Traces in the category of authentication

bss - Traces in the category of BSSIDsBasic Service Set Identifier. The BSSID identifies a particular BSS within an area. In infrastructure BSS networks, the BSSID is the MAC address of the AP. In independent BSS or ad hoc networks, the BSSID is generated randomly.

cluster - Traces in the category of cluster

config - Traces in the category of configuration

enet - Traces in the category of AP Enet port management

gsm - Traces in the category of GSM

radio - Traces in the category of radio

sapm - Traces in the category of cluster

sos - Traces in the category of SOS

station - Traces in the category of stations

syslog - Traces in the category of syslog

system - Traces in the category of general system

ip-addr <ip-addr>

Trace events related to the AP IP address.

loglevel

The loglevel of the syslogs to be included in the trace.

alert - Trace all logs equal or higher than LOG_ALERT

critical - Trace all logs equal or higher than LOG_CRIT

debug - Trace all logs equal or higher than LOG_DEBUG

emergency - Trace all logs equal or higher than LOG_EMERG

error - Trace all logs equal or higher than LOG_ERR

info - Trace all logs equal or higher than LOG_INFO

notice - Trace all logs equal or higher than LOG_NOTICE

warn - Trace all logs equal or higher than LOG_WARN

mac <mac>

Trace events related to the client MACMedia Access Control. A MAC address is a unique identifier assigned to network interfaces for communications on a network. address.

Examples

You can use the following command to trace all events related to the IP address.

(host) [mynode] #ap debug stm-trace category all ip-addr <ip-addr>

(host) [mynode] #ap debug stm-trace category all 10.20.10.20

Command History

Release

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

License

Command Mode

All platforms

Base operating system.

Enable mode on Mobility Master.

/*]]>*/