You are here: Home > CLI Commands > Just_CLI_Topics > ap deploy-profile

ap deploy-profile

ap deploy-profile

blacklist

default-ap-group

enable

ip-range <start> <end>

ipv6-range <start> <end>

no

Description

This command applies the AP deployment policy to the default AP group, and/or to the list of AP MACMedia Access Control. A MAC address is a unique identifier assigned to network interfaces for communications on a network. addresses included in the UAP blacklist table, and/or to the specified IP address range. The AP deployment policy redirects the applicable APs to the Instant discovery process, ensuring that the APs run only in controller-less mode.

Syntax

Parameter

Description

Range

Default

blacklist

Enables the blacklist policy. Applies the AP deployment policy to the APs whose MACMedia Access Control. A MAC address is a unique identifier assigned to network interfaces for communications on a network. addresses are included in the UAP blacklist table.

disabled

default-ap-group

Applies the AP deployment policy to the default AP group.

disabled

enable

Enables the AP deploy profile. The policies configured are enforced only if this is enabled.

disabled

ip-range

Applies the AP deployment policy to the specified IPv4 address range. You can define up to 128 IPv4 address ranges.

<start>

Starting IPv4 address of the range.

<end>

Ending IPv4 address of the range.

ipv6-range

Applies the AP deployment policy to the specified IPv6 address range. You can define up to 128 IPv6 address ranges.

<start>

Starting IPv6 address of the range.

<end>

Ending IPv6 address of the range.

no

Removes the AP deploy profile configuration.

Example

The following set of commands enable the AP deployment policy :

(host) [mynode] (config) #ap deploy-profile

(host) [mynode] (ap deploy-profile) #enable

The following command applies the AP deployment policy to an IPv4 address range with a starting IP address of 1.1.1.1 and ending IP address of 1.1.1.10:

(host) [mynode] (ap deploy-profile) #ip-range <1.1.1.1> <1.1.1.10>

The following command enables the blacklist policy in the AP deploy profile:

(host) [mynode] (ap deploy-profile) #blacklist

The following command removes the AP deployment policy configuration:

(host) [mynode] (config) #no ap deploy-profile

Related Commands

Command

Description

show ap deploy-profile

The show ap deploy-profile command displays the complete list of IP address ranges to which the AP deployment policy is applied.

uap-blacklist

This command adds AP MACMedia Access Control. A MAC address is a unique identifier assigned to network interfaces for communications on a network. addresses to the UAP blacklist database. When the blacklist policy is enabled in the AP deploy profile, it is applied to this blacklist database entries.

Command History

Release

Modification

ArubaOS 8.2.0.0

Command introduced.

Command Information

Platforms

License

Command Mode

All platforms

Base operating system.

Config mode on master Mobility Master.

/*]]>*/