You are here: Home > CLI Commands > Just_CLI_Topics > ap enet-link-profile

ap enet-link-profile

ap enet-link-profile {default | <profile>}

clone {default | <source>}

dot3az

dot3bz

duplex {auto | full | half}

no ...

poe

speed {10 | 100 | 1000 | 2500 | 5000 | auto}

Description

This command configures an AP EthernetEthernet is a network protocol for data transmission over LAN. link profile.

Syntax

Parameter

Description

Range

Default

ap enet-link-profile <profile>

Name of this instance of the profile. The name must be 1-63 characters long.

default

clone <source>

Name of an existing EthernetEthernet is a network protocol for data transmission over LAN. Link profile from which parameter values are copied.

default

dot3az

Enable support for the 803.az Energy Efficient Ethernet standard, which allows the APs to consume less power during periods of low data activity.

If this feature is enabled for an AP group, any APs in the group that do not support 803.az will ignore this setting.

disabled

 

dot3bz

Enable support for IEEEInstitute of Electrical and Electronics Engineers. 802.3bz standard. Only 330 Series access points are compliant with this standard.

enabled

duplex

The duplex mode of the EthernetEthernet is a network protocol for data transmission over LAN. interface, either full, half, or auto-negotiated.

full
half
auto

auto

no

Negates any configured parameter.

poe

 

Enables PoEPower over Ethernet. PoE is a technology for wired Ethernet LANs to carry electric power required for the device in the data cables. The IEEE 802.3af PoE standard provides up to 15.4 W of power on each port. for APs that support PoEPower over Ethernet. PoE is a technology for wired Ethernet LANs to carry electric power required for the device in the data cables. The IEEE 802.3af PoE standard provides up to 15.4 W of power on each port..

speed

The speed of the EthernetEthernet is a network protocol for data transmission over LAN. interface, either 10 MbpsMegabits per second, 100 MbpsMegabits per second, 1000 MbpsMegabits per second (1 GbpsGigabits per second.), or auto-negotiated.

10
100
1000
2500
5000
auto

auto

Usage Guidelines

This command configures the duplex and speed of the EthernetEthernet is a network protocol for data transmission over LAN. port on the AP. The configurable speed is dependent on the port type.

Example

The following command configures the EthernetEthernet is a network protocol for data transmission over LAN. link profile for full-duplex and 100 MbpsMegabits per second:

(host) [mynode] (config) #ap enet-link-profile enet

(host) [mynode] (AP Ethernet Link profile "enet") #duplex full

(host) [mynode] (AP Ethernet Link profile "enet") #speed 100

Command History

Release

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

License

Command Mode

Available on all platforms

Base operating system.

Config mode on Mobility Master.

/*]]>*/