You are here: Home > CLI Commands > Just_CLI_Topics > ap-leds

ap-leds

ap-leds

{all | ap-group <ap-group> | ap-name <ap-name> | ip-addr <ip address> | wired-mac <mac address>}

Description

This command allows you to set the behavior of an AP’s LEDs.

Syntax

Parameter

Description

all

Controls the LEDLight Emitting Diode. LED is a semiconductor light source that emits light when an electric current passes through it. behavior for all APs

global

Selects all APs on all controllers.

blink: Make LEDs blink for identification.

normal: Restore LEDs to their normal behavior.

local

Selects all APs registered on this controller.

ap-group <ap-group>

Controls the LEDLight Emitting Diode. LED is a semiconductor light source that emits light when an electric current passes through it. behavior for APs in the specified group.

ap-name <ap-name>

Controls the LEDLight Emitting Diode. LED is a semiconductor light source that emits light when an electric current passes through it. behavior for the AP with the specified name.

ip-addr <ip-addr>

Controls the LEDLight Emitting Diode. LED is a semiconductor light source that emits light when an electric current passes through it. behavior for the AP with the specified IP address.

wired-mac <mac-addr>

Controls the LEDLight Emitting Diode. LED is a semiconductor light source that emits light when an electric current passes through it. behavior for the AP with the specified MACMedia Access Control. A MAC address is a unique identifier assigned to network interfaces for communications on a network. address.

Usage Guidelines

Use the ap-leds command to make the LEDs on a defined set of APs either blink or display in the currently configured LEDLight Emitting Diode. LED is a semiconductor light source that emits light when an electric current passes through it. operating mode. Note that if the LEDLight Emitting Diode. LED is a semiconductor light source that emits light when an electric current passes through it. operating mode defined in the AP’s system profile is set to “off”, then the normal parameter in the ap-leds command will disable the LEDs. If the LEDLight Emitting Diode. LED is a semiconductor light source that emits light when an electric current passes through it. operating mode in the AP system profile is set to “normal” then the normal parameter in this command will allow the LEDs light as usual.

Example

The following command causes all local APs to blink their LEDs for identification purposes:

(host) [mynode] (config) #ap-leds

Command History

Release

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

License

Command Mode

All platforms

Base operating system.

Config mode on Mobility Master.

/*]]>*/