You are here: Home > CLI Commands > Just_CLI_Topics > ap multizone-profile

ap multizone-profile

ap multizone-profile <profile-name>

clone <source>

datazone <zone>

controller-ip <ipv4>

controller-ipv6 <ipv6>

description <description>

max-nodes <num_nodes>

max-vaps <num_nodes>

multizone-enable

no

primaryzone

max-nodes <num_nodes>

max-vaps <num_nodes>

Description

MultiZone feature allows AP to terminate to multiple managed devices that reside in different zones. A zone is a collection of managed devices under a single administration domain. The zone can have a single managed device or a cluster. This command allows you to create an AP MultiZone profile, set the data zone index, and controller-ip.

Syntax

Parameter

Description

<profile-name>

Name of the profile.

clone

Copy data from one AP MultiZone profile to another.

datazone

Data zone Index [1 - 4].

controller-ip <ipv4>

The IPv4 address of the managed device to be configured on one of the data zones.

controller-ipv6 <ipv6>

The IPv6 address of the managed device to be configured on one of the data zones.

description <description>

The description of the data zone. The range of the string is 1-32.

max-nodes <num_nodes>

(Optional) The maximum number of managed devices allowed for the data zone. The range should be between 1 – 11, as the primary zone must have at least one managed device. Default value is 1.

max-vaps <num_vaps>

(Optional) The maximum number of ESSIDsExtended Service Set Identifier. ESSID refers to the ID used for identifying an extended service set. allowed for the data zone. The range should be between 1 - 16. Default value is 3.

multizone-enable

If enabled, AP enters MultiZone mode. Default value is disabled.

no

Delete command.

primaryzone

This parameter is used to configure the primary zone.

max-nodes <num_nodes>

(Optional) The maximum number of managed devices allowed for the primary zone. The range should be between 1 – 11, as the primary zone must have at least one managed device. Default value is 1.

max-vaps <num_vaps>

(Optional) The maximum number of ESSIDsExtended Service Set Identifier. ESSID refers to the ID used for identifying an extended service set. allowed for the primary zone. The range should be between 1 - 16. Default value is 3.

Example

The following command enables AP MultiZone.

(host) [mynode] (config) #ap multizone-profile <default> multizone-enable

The following command configures IPv6 address of the managed device and sets maximum number of managed devices and ESSIDsExtended Service Set Identifier. ESSID refers to the ID used for identifying an extended service set. on the data zone:

(host) [mynode] (config) (ap multizone-profile <default>)# datazone 1 controller-ipv6 2001:1001::201 max-nodes 2 max-vaps 3

Command History

Release

Modification

ArubaOS 8.4.0.0

The following sub-parameters were introduced in the datazone parameter:

controller-ipv6 <ipv6>

description <description>

max-nodes <num_nodes>

max-vaps <num_vaps>

The following sub-parameters were introduced in the primaryzone parameter:

max-nodes <num_nodes>

max-vaps <num_vaps>

ArubaOS 8.1.0.0

The primaryzone parameter was introduced.

ArubaOS 8.0.1.0

The num-nodes sub-parameter was introduced.

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

License

Command Mode

Available on all platforms

Base operating system.

Config mode on Mobility Master.

/*]]>*/