You are here: Home > CLI Commands > Just_CLI_Topics > arp

arp

arp <ipaddr> <macaddr>

Description

This command adds a static Address Resolution Protocol (ARPAddress Resolution Protocol. ARP is used for mapping IP network address to the hardware MAC address of a device. ) entry.

Syntax

Parameter

Description

<ipaddr>

IP address of the device to be added.

<macaddr>

Hardware address of the device to be added, in the format xx:xx:xx:xx:xx:xx.

Usage Guidelines

If the IP address does not belong to a valid IP subnetwork, the ARPAddress Resolution Protocol. ARP is used for mapping IP network address to the hardware MAC address of a device. entry is not added. If the IP interface that defines the subnetwork for the static ARPAddress Resolution Protocol. ARP is used for mapping IP network address to the hardware MAC address of a device. entry is deleted, you will be unable to use the arp command to overwrite the entry’s current values; use the no arp command to negate the entry and then enter a new arp command.

Example

The following command configures an ARPAddress Resolution Protocol. ARP is used for mapping IP network address to the hardware MAC address of a device. entry:

(host)[node](config) #arp 10.152.23.237 00:0B:86:01:7A:C0

Command History

Release

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

m

Licensing

Command Mode

All platforms

Base operating system.

Config mode on Mobility Master.

/*]]>*/