You are here: Home > CLI Commands > Just_CLI_Topics > cluster-debug

cluster-debug

cluster-debug

bucketmap essid <essid_name> bucketindex <buck_idx> active <active_uac_idx> standby <standby_uac_idx>

standby-aac reassign [[active-aac-ip] <active_aac> [active-aac-ip6]] <active_aac_v6> [[standby-aac-ip] [standby-aac-ip6]] <new_standby_aac> <new_standby_aac_v6> [ap-group] <ap-group> [ap-mac] <ap-mac>

calc-sta-uac <sta_mac> <essid_name>

Description

This command set is used to change the bucketmap entries and to reassign the standby AAC. However, changing the bucketmap entries is not recommended by Aruba.

Syntax

Parameter

Description

bucketmap

Bucket map.

essid <essid_name>

EssidExtended Service Set Identifier. ESSID refers to the ID used for identifying an extended service set. name.

Bucketindex

Index within bucket map. The valid range of values for index is <0-255>.

active

Index of UAC in bucket map's UAC List. The valid range of values for index is <0-11>.

standby-uac

Standby UAC . Index of UAC in bucket map's UAC List or -1 if no standby desired. The valid range of values for index is <0-11>.

calc-sta-uac

Calculate station UAC and index by using bucketmap in GSM channel.

<sta_mac>

Enter the station MACMedia Access Control. A MAC address is a unique identifier assigned to network interfaces for communications on a network.  Address.

<essid_name>

Enter the EssidExtended Service Set Identifier. ESSID refers to the ID used for identifying an extended service set. name.

standby-aac

Standby AAC.

reassign

Reassign Standby AAC.

active-aac-ip <active_aac>

Active AAC IP Address. Enter the IP address of Active AAC. Use the following parameters:

standby-aac-ip <new_standby_aac>: Enter the IP Address of new standby AAC.

standby-aac-ip6 <new_standby_aac_v6> : Enter the IPv6 Address of new standby AAC.

active-aac-ip6 <active_aac_v6>

Active AAC IPv6 Address. Enter the IPv6 address of Active AAC.

ap-group <ap-group>

Enter the AP Group name. Use the following parameters:

active-aac-ip <active_aac>: Enter the IP Address of active AAC.

active-aac-ip6 <active_aac_v6>: Enter the IPv6 Address of active AAC.

standby-aac-ip <new_standby_aac>: Enter the IP Address of new standby AAC.

standby-aac-ip6 <new_standby_aac_v6>: Enter the IPv6 Address of new standby AAC.

ap-mac <ap_mac>

Enter the AP Mac Address.

Command History

Release

Modification

ArubaOS 8.2.0.0

The calc-sta-uac parameter was added.

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

Licensing

Command Mode

All platforms

Base operating system.

Config mode on managed devices.

/*]]>*/