You are here: Home > CLI Commands > Just_CLI_Topics > interface mgmt

interface mgmt

interface mgmt

dhcp

ip address <ipaddr> <ipmask> [vlan-tag <vlanid>]

ipv6 address <ipaddr>/<prefix-length> [vlan-tag <vlanid>]

no ...

shutdown

Description

This command configures the out-of-bandBand refers to a specified range of frequencies of electromagnetic radiation. EthernetEthernet is a network protocol for data transmission over LAN. management port on controller.

Syntax

Parameter

Description

dhcp

Enables DHCPDynamic Host Configuration Protocol. A network protocol that enables a server to automatically assign an IP address to an IP-enabled device from a defined range of numbers configured for a given network.  on the interface.

ip address

Configures an IP address and netmaskNetmask is a 32-bit mask used for segregating IP address into subnets. Netmask defines the class and range of IP addresses. on the interface.

vlan-tag <vlanid>

(Optional) Tags the management interface with the specified VLANVirtual Local Area Network. In computer networking, a single Layer 2 network may be partitioned to create multiple distinct broadcast domains, which are mutually isolated so that packets can only pass between them through one or more routers; such a domain is referred to as a Virtual Local Area Network, Virtual LAN, or VLAN. ID.

ipv6 address <ipaddr>

Configures an IPv6 address on the interface.

vlan-tag <vlanid>

(Optional) Tags the management interface with the specified VLANVirtual Local Area Network. In computer networking, a single Layer 2 network may be partitioned to create multiple distinct broadcast domains, which are mutually isolated so that packets can only pass between them through one or more routers; such a domain is referred to as a Virtual Local Area Network, Virtual LAN, or VLAN. ID.

no

Negates any configured parameter.

shutdown

Causes a hard shutdown of the interface.

Usage Guidelines

Execute this command on the device level from the Mobility Master. This command is applicable only for the 7000 Series platforms.

Use the show interface mgmt command to view the current status of the management port.

Example

The following command configures an IP address on the management interface:

(host) [mynode] (config) #interface mgmt

(host) [mynode] (config-submode) #ip address 10.1.1.1 255.255.255.0

Command History

Release

Modification

ArubaOS 8.0.1.0

vlan-tag optional sub-parameter was introduced under the ip address and ipv6 address parameters.

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

License

Command Mode

7000 Series controllers

Base operating system.

Config mode on Mobility Master.

/*]]>*/