You are here: Home > CLI Commands > Just_CLI_Topics > ipv6 local

ipv6 local

ipv6 local

pool <pool_name_v6> <pool_start_addressv6> <pool_end_addressv6>

Description

This command configures a local IPv6 pool for Layer-2 Tunnel Protocol (L2TPLayer-2 Tunneling Protocol. L2TP is a networking protocol used by the ISPs to enable VPN operations. ).

Syntax

Parameter

Description

pool

Name for the address pool.

<pool_start_addressv6>

Starting IPv6 address for the pool.

<pool_end_addressv6>

(Optional) Ending IPv6 address for the pool.

Usage Guidelines

VPNVirtual Private Network. VPN enables secure access to a corporate network when located remotely. It enables a computer to send and receive data across shared or public networks as if it were directly connected to the private network, while benefiting from the functionality, security, and management policies of the private network. This is done by establishing a virtual point-to-point connection through the use of dedicated connections, encryption, or a combination of the two. clients can be assigned IPv6 addresses from the L2TPLayer-2 Tunneling Protocol. L2TP is a networking protocol used by the ISPs to enable VPN operations. pool.

Example

The following command configures a local IPv6 pool:

(host) [mynode] (config) #ipv6 local pool 2001:0000:0eab:DEAD:0000:OOAO:ABCD:004E 2002:0000:0eab:DEAD:0000:OOAO:ABCD:004E

Command History

Release

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

License

Command Mode

Available on all platforms

Available in the base operating system.

Config mode on Mobility Master.

/*]]>*/