You are here: Home > CLI Commands > Just_CLI_Topics > sesimagotag-esl-channel

sesimagotag-esl-channel

sesimagotag-esl-channel <sesImagotag-esl-channel>

Description

This command configures the radio channel of SES-imagotag ESL system.

Syntax

Parameter

Description

Range Default

sesimagotag-esl-channel

The channel of SES-imagotag ESL radio.

0-10

Usage Guidelines

The SES-imagotag ESL system operates on the 2.4 GHzGigahertz. frequency. In order to configure the operating channel, ensure that the SES USBUniversal Serial Bus. USB is a connection standard that offers a common interface for communication between the external devices and a computer. USB is the most common port used in the client devices. dongle is plugged into the Aruba AP. The sesImagotag-esl-channel command is used to configure the radio channel for data transmission. The SES dongle communicates with labels to display the information defined by the control center. There are 11 pre-defined, independent radio channels that you can configure. The recommended channels are 3, 5, 8, 9, and 10 as they connect faster. These channels do not correspond to the standard 802.11802.11 is an evolving family of specifications for wireless LANs developed by a working group of the Institute of Electrical and Electronics Engineers (IEEE). 802.11 standards use the Ethernet protocol and Carrier Sense Multiple Access with collision avoidance (CSMA/CA) for path sharing. channels.

Example

The following example sets the radio channel to 3:

(host) [mynode] (config) #ap system-profile sys

(host) [mynode] (AP system profile "sys") #sesimagotag-esl-channel 3

Command History

Release

Modification

ArubaOS 8.4.0.0

Command introduced.

Command Information

Platforms

License

Command Mode

AP-303H, 300 Series access points, 310 Series access points, 320 Series access points, 330 Series access points, 340 Series access points, and 510 Series access points

Base operating system.

Config mode on Mobility Master.

/*]]>*/