You are here: Home > CLI Commands > Just_CLI_Topics > show adp counters

show adp counters

show adp counters

Description

Show Aruba Discovery Protocol (ADPAruba Discovery Protocol. ADP is an Aruba proprietary Layer 2 protocol. It is used by the APs to obtain the IP address of the TFTP server from which it downloads the AP boot image.) counters.

Syntax

No parameters.

Example

The following example shows the ADPAruba Discovery Protocol. ADP is an Aruba proprietary Layer 2 protocol. It is used by the APs to obtain the IP address of the TFTP server from which it downloads the AP boot image. counter table for the managed device.

 

(host)[mynode](config) #show adp counters

ADP Counters

------------

key value

--- -----

IGMP Join Tx 1

IGMP Drop Tx 0

ADP Tx 0

ADP Rx 0

 

The output of this command includes the following parameters:

Parameter

Description

IGMP Join Tx

Number of Internet Group Management Protocol (IGMPInternet Group Management Protocol. Communications protocol used by hosts and adjacent routers on IP networks to establish multicast group memberships.) join requests sent by the managed device.

IGMP Drop Tx

Number of Internet Group Management Protocol (IGMPInternet Group Management Protocol. Communications protocol used by hosts and adjacent routers on IP networks to establish multicast group memberships.) drop requests sent by the managed device.

ADP Tx

Number of ADPAruba Discovery Protocol. ADP is an Aruba proprietary Layer 2 protocol. It is used by the APs to obtain the IP address of the TFTP server from which it downloads the AP boot image. responses sent to APs.

ADP Rx

Number of multicast and broadcast queries received from APs trying to locate Mobility Master.

Related Commands

Command

Description

adp

This command configures the ADPAruba Discovery Protocol. ADP is an Aruba proprietary Layer 2 protocol. It is used by the APs to obtain the IP address of the TFTP server from which it downloads the AP boot image..

show adp config

Show Aruba Discovery Protocol (ADPAruba Discovery Protocol. ADP is an Aruba proprietary Layer 2 protocol. It is used by the APs to obtain the IP address of the TFTP server from which it downloads the AP boot image.) configuration settings.

Command History

Command

Description

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

Licensing

Command Mode

All platforms

Base operating system.

Enable or Config mode on Mobility Master.

/*]]>*/