You are here: Home > CLI Commands > Just_CLI_Topics > show ap arm client-match neighbors

show ap arm client-match neighbors

show ap arm client-match neighbors

ap-name <name>

ip-addr <ipaddr>

ip6-addr <ipaddr>

Description

If the client match feature is enabled, the output of this command displays the BSSIDBasic Service Set Identifier. The BSSID identifies a particular BSS within an area. In infrastructure BSS networks, the BSSID is the MAC address of the AP. In independent BSS or ad hoc networks, the BSSID is generated randomly. of other APs seen by clients in the select AP's RFRadio Frequency. RF refers to the electromagnetic wave frequencies within a range of 3 kHz to 300 GHz, including the frequencies used for communications or Radar signals. neighborhood.

Syntax

Parameter

Description

ap-name <name>

View neighboring clients for an AP with a specified name

ip-addr <ipaddr>

View neighboring clients for an AP with a specified IP address.

ipv6-addr <ipaddr>

View neighboring clients for an AP with a specified IPv6 address.

Usage Guidelines

Issue this command to view a list of other APs seen by clients currently associated to the selected AP.

Example

The example below indicates that the clients currently associated to the AP can detect signals from three other APs.

(host)#show ap arm client-match neighbors ap-name <ap-name>

Client View

------------

BSSID Channel

----- -------

d8:c7:c8:37:84:70 132

d8:c7:c8:88:b6:50 132

d8:c7:c8:37:84:10 124

Num Neighbors:3

The output of this command includes the following parameters:

Parameter Description
Client MACMedia Access Control. A MAC address is a unique identifier assigned to network interfaces for communications on a network.

AP name of the AP from which the client can detect a signal.

Signal

Signal strength, in dBmDecibel-Milliwatts. dBm is a logarithmic measurement (integer) that is typically used in place of mW to represent receive-power level. AMP normalizes all signals to dBm, so that it is easy to evaluate performance between various vendors., of the probe request received from Client

Assoc

A "Y" in this field indicates that the client is currently associated to that AP radio.

Sec since last heard

Time elapsed since the AP radio heard from the client.

Sec since last reported

Time elapsed since the AP radio heard from the client.

Last heard

Date and time at which the AP last heard from the client

Related Commands

Command

Description

rf arm-profile

This command enables ClientMatch.

show ap arm client-match probe-report

This command displays the client probe report for the specified AP.

show ap arm virtual-beacon-report

This command displays the virtual beacon report for an AP with a specific IP or MACMedia Access Control. A MAC address is a unique identifier assigned to network interfaces for communications on a network. address.

show ap arm client-match unsupported

This command displays a list of clients that failed to be steered to a more optimal AP, and the reason the initial steering request was triggered.

show ap arm client-match summary

This command shows the history of AP association changes triggered by the client match feature.

show ap arm client-match history

This command shows the history of AP association changes triggered by the client match feature.

show ap arm client-match restriction-table

This command displays the list of clients that ClientMatch has restricted from the specified AP.

Command History

Release

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

Licensing

Command Mode

All platforms

Base operating system.

Enable or Config mode on Mobility Master.

/*]]>*/