You are here: Home > CLI Commands > Just_CLI_Topics > show ap arm virtual-beacon-report

show ap arm virtual-beacon-report

show ap arm virtual-beacon-report

ap-name <name>

ip-addr <ipaddr>

ip6-addr <ip6-addr>

phy-type 80211a|80211b|80211g

Description

If the client match feature is enabled, the output of this command displays the virtual beacon report for an AP with a specific IP or MACMedia Access Control. A MAC address is a unique identifier assigned to network interfaces for communications on a network. address.

Syntax

Parameter

Description

ap-name <name>

Name of an AP for which you want to view a virtual beacon report.

ip-addr <ipaddr>

IPv4 address of an AP for which you want to view a virtual beacon report.

ip6-addr <ipv6addr>

IPv6 address of an AP for which you want to view a virtual beacon report.

phy-type

Display virtual beacon report data for an AP radio with one of the following phy types:

80211a

80211b

80211g

Usage Guidelines

If the client match feature is enabled, the managed device sends APs a list of clients that should not be allowed to associate to that AP.

Example

(host)[node] #show ap arm virtual-beacon-report ap-name 1263-ac

 

Interface:wifi0

Rx VBR Reports:683

 

Client MAC:24:77:03:cf:fa:5c

Dual band:Yes

Active Voice:No

Steerable:Yes

Dual network capable:No

Current Association:6c:f3:7f:e7:5a:b0

 

Virtual Beacon Report

---------------------

AP Channel Signal (dBm) EIRP Assoc

-- ------- ------------ ---- -----

9c:1c:12:fd:d2:10 60 -76 12

9c:1c:12:fd:d2:00 1 -66 12

9c:1c:12:fe:13:50 52 -73 21

9c:1c:12:fe:0f:d0 52 -74 24

9c:1c:12:fd:f7:b0 44 -49 20

6c:f3:7f:e7:5a:b0 60 -73 12 Y

9c:1c:12:fd:f2:30 60 -69 12

9c:1c:12:fd:f7:a0 1 -55 12

9c:1c:12:fd:f2:20 1 -65 12

9c:1c:12:fe:13:40 1 -68 12

The output of this command includes the following parameters:

Parameter Description
AP

MACMedia Access Control. A MAC address is a unique identifier assigned to network interfaces for communications on a network. address of the AP from which the client can detect a signal

Channel

Channel on which the signal was deteched

Signal

Signal strength, in dBmDecibel-Milliwatts. dBm is a logarithmic measurement (integer) that is typically used in place of mW to represent receive-power level. AMP normalizes all signals to dBm, so that it is easy to evaluate performance between various vendors., of the probe request received from Client

EIRPEffective Isotropic Radiated Power or Equivalent Isotropic Radiated Power. EIRP refers to the output power generated when a signal is concentrated into a smaller area by the Antenna.

Amount of power transmitted from the AP antennae

Assoc

A "Y" in this field indicates that the client is currently associated to that AP radio

Related Commands

Command

Description

rf arm-profile

This command enables ClientMatch.

Command History

Command

Description

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

Licensing

Command Mode

All platforms

Base operating system.

Enable or Config mode on Mobility Master.

/*]]>*/