You are here: Home > CLI Commands > Just_CLI_Topics > show ap debug client-trace clients

show ap debug client-trace clients

show ap debug client-trace clients {ap-name <ap-name>}|{ip-addr <ip-addr>}|{ip6-addr <ip6-addr>}

Description

This command shows debug client trace for all registered clients in an AP.

Syntax

Parameter

Description

ap-name <ap-name>

Shows debug client trace for all registered clients in an AP for specified AP name.

ip-addr <ip-addr>

Shows debug client trace for all registered clients in an AP for specified IP address.

ip6-addr <ip6-addr>

Shows debug client trace for all registered clients in an AP for specified IPv6 address.

Usage Guidelines

This command shows debug client trace for all registered clients in an AP. For the remaining parameters, see the command syntax.

Example

The following example shows an AP named ap-205 does not support the show ap debug client-trace clients command:

(host) [mynode] #show ap debug client-trace clients ap-name ap-205

 

The AP platform do not support the command

Related Commands

Command

Description

ap deploy-profile

This command applies the AP deployment policy to the default AP group, and/or to the list of AP MACMedia Access Control. A MAC address is a unique identifier assigned to network interfaces for communications on a network. addresses included in the UAP blacklist table, and/or to the specified IP address range. The AP deployment policy redirects the applicable APs to the Instant discovery process, ensuring that the APs run only in controller-less mode.

Command History:

Release

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

Licensing

Command Mode

All platforms

Base operating system.

Enable mode on Mobility Master.

/*]]>*/