You are here: Home > CLI Commands > Just_CLI_Topics > show ap load-balancing

show ap load-balancing

show ap load balancing

Description

Show the load-balancing information for each AP with load balancing enabled.

Examples

The output of the command in the example below shows details for a single AP enabled with the load-balancing feature.

(host) [mynode] #show ap load-balancing

Load Balance Enabled Access Point Table

---------------------------------------

bss ess name s/p ip phy chan cur-cl util(kbps)

--- --- ---- --- -- --- ---- ------ ----------

00:0b:86:cc:8e:4e Wireless_1 mp22 2/24 10.3.148.12 a-HT 413 3 14

The output of this command includes the following information:

Column

Description

BSS

The Basic Service Set (BSSBasic Service Set. A BSS is a set of interconnected stations that can communicate with each other. BSS can be an independent BSS or infrastructure BSS. An independent BSS is an ad hoc network that does not include APs, whereas the infrastructure BSS consists of an AP and all its associated clients. ) Identifier for the AP. This is usually the APs MACMedia Access Control. A MAC address is a unique identifier assigned to network interfaces for communications on a network. address.

ESS

The Extended Service Set (ESSExtended Service Set. An ESS is a set of one or more interconnected BSSs that form a single sub network. ) Identifier is the user-defined name of an 802.11802.11 is an evolving family of specifications for wireless LANs developed by a working group of the Institute of Electrical and Electronics Engineers (IEEE). 802.11 standards use the Ethernet protocol and Carrier Sense Multiple Access with collision avoidance (CSMA/CA) for path sharing. wireless network.

s/p

The controller slot and port used by the AP, in the format <slot>/<module>/<port>.

ip

IP address of the AP.

phy

One of the following 802.11802.11 is an evolving family of specifications for wireless LANs developed by a working group of the Institute of Electrical and Electronics Engineers (IEEE). 802.11 standards use the Ethernet protocol and Carrier Sense Multiple Access with collision avoidance (CSMA/CA) for path sharing. types

a

a-HTHigh Throughput. IEEE 802.11n is an HT WLAN standard that aims to achieve physical data rates of close to 600 Mbps on the 2.4 GHz and 5 GHz bands. (high-throughput)

g

g-HTHigh Throughput. IEEE 802.11n is an HT WLAN standard that aims to achieve physical data rates of close to 600 Mbps on the 2.4 GHz and 5 GHz bands. (high-throughput)

chan

Channel number for the AP 802.11a802.11a provides specifications for wireless systems. Networks using 802.11a operate at radio frequencies in the 5 GHz band. The specification uses a modulation scheme known as orthogonal frequency-division multiplexing (OFDM) that is especially well suited to use in office settings. The maximum data transfer rate is 54 Mbps./802.11n802.11n is a wireless networking standard to improve network throughput over the two previous standards, 802.11a and 802.11g. With 802.11n, there will be a significant increase in the maximum raw data rate from 54 Mbps to 600 Mbps with the use of four spatial streams at a channel width of 40 MHz. physical layer. The available channels depend on the AP’s regulatory domain (country).

cur-cl

Current number of clients on the AP.

util (kbps)

Current bandwidth utilization, in kbps.

Related Commands

Command

Description

uplink

This manages and configures the uplink network connection.

Command History

Version

Modification

ArubaOS 8.0.0.0

Command introduced

Command Information

Platforms

Licensing

Command Mode

All platforms

Base operating system.

Enable mode on Mobility Master.

/*]]>*/