You are here: Home > CLI Commands > Just_CLI_Topics > show ap papi-err

show ap papi-err

show ap papi-err {ap-name <ap-name>|bssid <bssid>|ip-addr <ip-addr>|ip6-addr <ip6-addr>}

Description

Show PAPIProcess Application Programming Interface. PAPI controls channels for ARM and Wireless Intrusion Detection System (WIDS) communication to the master controller. A separate PAPI control channel connects to the local controller where the SSID tunnels terminate.  error messages.

Syntax

Parameter

Description

ap-name <ap-name>

Show data for an AP with a specific name.

bssid <bssid>

Show data for a specific Basic Service Set Identifier (BSSIDBasic Service Set Identifier. The BSSID identifies a particular BSS within an area. In infrastructure BSS networks, the BSSID is the MAC address of the AP. In independent BSS or ad hoc networks, the BSSID is generated randomly.) on an AP. The Basic Service Set Identifier (BSSIDBasic Service Set Identifier. The BSSID identifies a particular BSS within an area. In infrastructure BSS networks, the BSSID is the MAC address of the AP. In independent BSS or ad hoc networks, the BSSID is generated randomly.) is usually the AP’s MACMedia Access Control. A MAC address is a unique identifier assigned to network interfaces for communications on a network. address.

ip-addr <ip-addr>

Show data for an AP with a specific IP address by entering its IP address in dotted-decimal format.

ip6-addr <ip6-addr>

Show data for an AP with a specific IPv6 address by entering its IPv6 address in dotted-decimal format.

Examples

The output of the command displays the status.

(host) #show ap papi-err

STM SAP PAPI Send Error

-----------------------

Name bssid ip Tunnel Add Tunnel Remove Arp Req Vlan Req Sta Req Mcast Req

---- ----- -- ---------- ------------- ------- -------- ------- ---------

Related Commands

Command

Description

papi-security

The papi-security command enforces advanced security options and provides an enhanced level of security. It allows to enable or disable the PAPIProcess Application Programming Interface. PAPI controls channels for ARM and Wireless Intrusion Detection System (WIDS) communication to the master controller. A separate PAPI control channel connects to the local controller where the SSID tunnels terminate. Enhanced Security configuration and to configure a new security key if required.

Command History

Command

Description

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

Licensing

Command Mode

All platforms

Base operating system.

Enable or Config mode on Mobility Master.

/*]]>*/