You are here: Home > CLI Commands > Just_CLI_Topics > show ap port status

show ap port status

ap-name <ap-name>

bssid <bssid>

ip-addr <ip-addr>

ip6-addr <ip6-addr>

wired-mac <wired-mac>


Shows the status of the AP's wired ports. The status is updated every 60 seconds.




ap-name <ap-name>

Name of the AP.

bssid <bssid>

BSSIDBasic Service Set Identifier. The BSSID identifies a particular BSS within an area. In infrastructure BSS networks, the BSSID is the MAC address of the AP. In independent BSS or ad hoc networks, the BSSID is generated randomly. of the AP.

ip-addr <ip-addr>

IP address of the AP.

ip6-addr <ip6-addr>

IPv6 address of the AP.

wired-mac <wired-mac>

MACMedia Access Control. A MAC address is a unique identifier assigned to network interfaces for communications on a network. address of the AP.


The output of the command displays the wired port status of an AP named LocalAP1. In this example, the output is divided into multiple sections to fit better on the pages of this document. In the actual CLICommand-Line Interface. A console interface with a command line shell that allows users to execute text input as commands and convert these commands to appropriate functions., it appears in a single long table.

(host) #show ap port status ap-name LocalAP1


AP "LocalAP1" Port Status (updated every 60 seconds)


Port MAC Type Forward Mode Admin Oper Speed Duplex 802.3az PoE

---- --- ---- ------------ ----- ---- ----- ------ ------- ---

0 00:1a:1e:10:05:1a GE N/A enabled up 1 Gb/s full N/A N/A

1 00:1a:1e:10:05:1b FE tunnel enabled up 100 Mb/s full N/A N/A

2 00:1a:1e:10:05:1c FE tunnel enabled down N/A N/A N/A N/A

3 00:1a:1e:10:05:1d FE N/A disabled down N/A N/A N/A N/A


STP TX-Packets TX-Bytes RX-Packets RX-Bytes

--- ---------- -------- ---------- --------

N/A 23697 3338307 27449 8471871

Forwarding 12185 6593226 18436 1758272

Disabled 0 0 0 0

Off 0 0 0 0

Related Commands



ap wired-port-profile

This command configures a wired port profile.

Command History




Command introduced.

Command Information



Command Mode

All platforms

Base operating system.

Enable or Config mode on Mobility Master.