You are here: Home > CLI Commands > Just_CLI_Topics > show ap provisioning-rule

show ap provisioning-rule

show ap provisioning-rule [<profile-name>]

Description

This command displays information for an AP provisioning rule.

Syntax

Parameter

Description

<profile-name>

The name of an existing AP provisioning rule.

Usage Guidelines

The optional output modifiers | begin , | exclude, and | include help you display those lines that begin, include, exclude, respectively, the line expression given in the CLICommand-Line Interface. A console interface with a command line shell that allows users to execute text input as commands and convert these commands to appropriate functions. command. The | redirect-output modifier helps you redirect the command output.

Examples

The following example shows the details of the conditions and actions for the AP provisioning rule: test.

(host) [mm] (config) #show ap provisioning-rule test ap provisioning rule "test" ---------------------------- Parameter Value --------- ----- ip range N/A network 3.3.3.3/1 any AP false AP Type AP-UNKNOWN ap group N/A Antenna gain for 802.11g N/A Antenna gain for 802.11a N/A Radio 0 5GHz Antenna gain for APs support Dual 5GHz mode N/A Radio 1 5GHz Antenna gain for APs support Dual 5GHz mode N/A

The output of this command includes the following information:

Parameter

Description

ip range

Indicates the IPv4 or IPv6 address range to check if the IP address of the AP is within this range.

network

Specifies the IPv4 or IPv6 network address to check if the IP address of the AP is within this network address.

any AP

Indicates if you want to apply the provisioning rule's condition to any AP.

AP Type

Indicates the AP model to apply the rule to this particular AP.

ap group

Indicates the AP group that you want to assign to the AP.

Antenna gain for 802.11g

Indicates the antenna gain for 802.11g802.11g offers transmission over relatively short distances at up to 54 Mbps, compared with the 11 Mbps theoretical maximum of 802.11b standard. 802.11g employs Orthogonal Frequency Division Multiplexing (OFDM), the modulation scheme used in 802.11a, to obtain higher data speed. Computers or terminals set up for 802.11g can fall back to speed of 11 Mbps, so that 802.11b and 802.11g devices can be compatible within a single network. (2.4 GHzGigahertz.) antenna.

Antenna gain for 802.11a

Indicates the antenna gain for 802.11a802.11a provides specifications for wireless systems. Networks using 802.11a operate at radio frequencies in the 5 GHz band. The specification uses a modulation scheme known as orthogonal frequency-division multiplexing (OFDM) that is especially well suited to use in office settings. The maximum data transfer rate is 54 Mbps. (5 GHzGigahertz.) antenna.

Radio 0 5GHz Antenna gain for APs support Dual 5GHz mode

Antenna gain for radio 0 (5 GHzGigahertz.) antenna. This parameter is only displayed for APs that support dual 5 GHzGigahertz. mode.

Radio 1 5GHz Antenna gain for APs support Dual 5GHz mode

Antenna gain for radio 1 (5 GHzGigahertz.) antenna. This parameter is only displayed for APs that support dual 5 GHzGigahertz. mode.

Related Commands

Command

Description

ap provisioning-rule

This command defines the conditions to select a group of APs and the subsequent actions to provision the APs.

Command History

Version

Modification

ArubaOS 8.4.0.0

Command introduced.

Command Information

Platforms

Licensing

Command Mode

All platforms

Base operating system.

Enable or Config mode on Mobility Master.

/*]]>*/