You are here: Home > CLI Commands > Just_CLI_Topics > show ap spectrum debug status

show ap spectrum debug status

show ap spectrum debug status {ap-name <ap-name> | ip-addr <ip-addr> | ip6-addr <ip6-addr>} [freq-band {2.4ghz | 5ghz}]

Description

This command shows detailed status and statistics for a spectrum monitor or hybrid AP.

Syntax

Parameter

Description

ap-name <ap-name>

Name of the spectrum device for which you want to view status information.

ip-addr <ip-addr>

IP address of the spectrum device for which you want to view status information.

ip6-addr <ip6-addr>

IPv6 address of the spectrum device for which you want to view status information.

freq-band 2.4ghz|5ghz

View information for a specific radio type, either 2.4 GHzGigahertz. or 5 GHzGigahertz..

Usage Guidelines

Use this command under the guidance of an Aruba technical support representative to troubleshoot spectrum analysis errors.

Example

The following is an example for executing this command:

(host) [mynode] #show ap spectrum debug status ap-name ap-205 freq-band 5ghz

Related Commands

Command

Description

ap spectrum local-override

Converts an AP or AMAir Monitor. AM is a mode of operation supported on wireless APs. When an AP operates in the Air Monitor mode, it enhances the wireless networks by collecting statistics, monitoring traffic, detecting intrusions, enforcing security policies, balancing wireless traffic load, self-healing coverage gaps, and more. However, clients cannot connect to APs operating in the AM mode. into a spectrum monitor by adding it to the spectrum local-override list.

rf dot11a-radio-profilemodespectrum-mode

Sets an 802.11a802.11a provides specifications for wireless systems. Networks using 802.11a operate at radio frequencies in the 5 GHz band. The specification uses a modulation scheme known as orthogonal frequency-division multiplexing (OFDM) that is especially well suited to use in office settings. The maximum data transfer rate is 54 Mbps. radio so that the device operates as a spectrum monitor, and can send spectrum analysis data to a desktop or laptop client.

rf dot11g-radio-profilemodespectrum-mode

Set an 802.11g802.11g offers transmission over relatively short distances at up to 54 Mbps, compared with the 11 Mbps theoretical maximum of 802.11b standard. 802.11g employs Orthogonal Frequency Division Multiplexing (OFDM), the modulation scheme used in 802.11a, to obtain higher data speed. Computers or terminals set up for 802.11g can fall back to speed of 11 Mbps, so that 802.11b and 802.11g devices can be compatible within a single network. radio so that the device operates as a spectrum monitor, and can send spectrum analysis data to a desktop or laptop client.

Command History

Release

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

License

Command Mode

All platforms

Base operating system.

Enable or Config mode on the managed device or controller where the AP terminates.

/*]]>*/