You are here: Home > CLI Commands > Just_CLI_Topics > show ap spectrum-load-balancing

show ap spectrum-load-balancing

show ap spectrum-load-balancing [group <group>]

Description

This command shows spectrum load balancing information for an AP with this feature enabled.

Syntax

Parameter

Description

group <group>

Filter this information to show only data for the specified spectrum load balancing domain.

Examples

The output of the command below shows the APs currently using the spectrum load-balancing domain default-1.

(host)[mynode] #show ap spectrum-load-balancing group default-1

 

Spectrum Load Balancing Group

-----------------------------

Name IP Address Domain Assignment Clients

---- ---------- ------ ---------- -------

ap121-1 192.168.151.253 default-1 149/21 3

ap124-1 192.168.151.254 default-1 48/15 3

ap125-1 192.168.151.251 default-1 44/15 2

The output of this command includes the following information:

Column

Description

Name

Name of an AP.

IP address

IP address of the AP.

Domain

Name of the spectrum load balancing domain assigned to the AP.

Assignment

Current channel and power assignment for the AP.

Clients

Number of clients currently using the AP.

Related Commands

Command

Description

ap spectrum local-override

Converts an AP or AMAir Monitor. AM is a mode of operation supported on wireless APs. When an AP operates in the Air Monitor mode, it enhances the wireless networks by collecting statistics, monitoring traffic, detecting intrusions, enforcing security policies, balancing wireless traffic load, self-healing coverage gaps, and more. However, clients cannot connect to APs operating in the AM mode. into a spectrum monitor by adding it to the spectrum local-override list.

rf dot11a-radio-profilemodespectrum-mode

Sets an 802.11a802.11a provides specifications for wireless systems. Networks using 802.11a operate at radio frequencies in the 5 GHz band. The specification uses a modulation scheme known as orthogonal frequency-division multiplexing (OFDM) that is especially well suited to use in office settings. The maximum data transfer rate is 54 Mbps. radio so that the device operates as a spectrum monitor, and can send spectrum analysis data to a desktop or laptop client.

rf dot11g-radio-profilemodespectrum-mode

Sets an 802.11g802.11g offers transmission over relatively short distances at up to 54 Mbps, compared with the 11 Mbps theoretical maximum of 802.11b standard. 802.11g employs Orthogonal Frequency Division Multiplexing (OFDM), the modulation scheme used in 802.11a, to obtain higher data speed. Computers or terminals set up for 802.11g can fall back to speed of 11 Mbps, so that 802.11b and 802.11g devices can be compatible within a single network. radio so that the device operates as a spectrum monitor, and can send spectrum analysis data to a desktop or laptop client.

Command History

Release

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

License

Command Mode

All platforms

Base operating system.

Enable or Config mode on the managed device or controller where the AP terminates.

/*]]>*/