You are here: Home > CLI Commands > Just_CLI_Topics > show ap spectrum local-override

show ap spectrum local-override

show ap spectrum local-override

Description

This command shows a list of AP radios currently converted to spectrum monitors through the spectrum local-override list.

Syntax

No parameters

Examples

The output of this example shows that three APs each have two radios defined as spectrum monitors.

(host)[mynode] #show ap spectrum local-override

Spectrum Local Override Profile

-------------------------------

Parameter Value

--------- -----

Override Entry AP ap125 band 2ghz

Override Entry AP ap125 band 5ghz

Override Entry AP ap105 band 2ghz

Override Entry AP ap105 band 5ghz

Override Entry AP apcorp1 band 2ghz

Override Entry AP APcorp1 band 5ghz

The Value column in the output of this command includes the following information:

Parameter

Description

Override Entry

Indicates that an AP radio has been added to the local override list.

Value

Radio that has been added to the override list, and the bandBand refers to a specified range of frequencies of electromagnetic radiation. used by that radio.

Related Commands

Command

Description

ap spectrum local-override

Converts an AP or AMAir Monitor. AM is a mode of operation supported on wireless APs. When an AP operates in the Air Monitor mode, it enhances the wireless networks by collecting statistics, monitoring traffic, detecting intrusions, enforcing security policies, balancing wireless traffic load, self-healing coverage gaps, and more. However, clients cannot connect to APs operating in the AM mode. into a spectrum monitor by adding it to the spectrum local-override list.

rf dot11a-radio-profilemode spectrum-mode

Sets an 802.11a802.11a provides specifications for wireless systems. Networks using 802.11a operate at radio frequencies in the 5 GHz band. The specification uses a modulation scheme known as orthogonal frequency-division multiplexing (OFDM) that is especially well suited to use in office settings. The maximum data transfer rate is 54 Mbps. radio so that the device operates as a spectrum monitor, and can send spectrum analysis data to a desktop or laptop client.

rf dot11g-radio-profilemode spectrum-mode

Sets an 802.11g802.11g offers transmission over relatively short distances at up to 54 Mbps, compared with the 11 Mbps theoretical maximum of 802.11b standard. 802.11g employs Orthogonal Frequency Division Multiplexing (OFDM), the modulation scheme used in 802.11a, to obtain higher data speed. Computers or terminals set up for 802.11g can fall back to speed of 11 Mbps, so that 802.11b and 802.11g devices can be compatible within a single network. radio so that the device operates as a spectrum monitor, and can send spectrum analysis data to a desktop or laptop client.

Command History

Release

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

License

Command Mode

All platforms

Base operating system.

Enable or Config mode on the managed device or controller where the AP terminates.

/*]]>*/