You are here: Home > CLI Commands > Just_CLI_Topics > show cluster-switches

show cluster-switches

show cluster-switches

Description

Execute this command on a Mobility Master using control plane security in a multi-master environment to show other managed devices to which it is connected.

Syntax

No parameters

Usage Guidelines

When you issue this command from the cluster root, the output of this command displays the IP address of the VLANVirtual Local Area Network. In computer networking, a single Layer 2 network may be partitioned to create multiple distinct broadcast domains, which are mutually isolated so that packets can only pass between them through one or more routers; such a domain is referred to as a Virtual Local Area Network, Virtual LAN, or VLAN. used by the cluster member to connect to the cluster root.

If you issue this command from a cluster member ,the output of this command displays the IP address of the VLANVirtual Local Area Network. In computer networking, a single Layer 2 network may be partitioned to create multiple distinct broadcast domains, which are mutually isolated so that packets can only pass between them through one or more routers; such a domain is referred to as a Virtual Local Area Network, Virtual LAN, or VLAN. used by the cluster root to connect to the cluster member.

Example

In the example below, the show cluster-switches command was issued on a cluster member. The Switch‑IP section of the output shows the IP address of a VLANVirtual Local Area Network. In computer networking, a single Layer 2 network may be partitioned to create multiple distinct broadcast domains, which are mutually isolated so that packets can only pass between them through one or more routers; such a domain is referred to as a Virtual Local Area Network, Virtual LAN, or VLAN. on cluster root, indicating that the cluster member can currently communicate with the cluster root. If the managed device cannot communicate with the cluster root, this table will be blank.

(host) [mynode] (config) #show cluster-switches

 

SWITCH-IP CLUSTER-ROLE

-----------------------------

172.21.18.18 ROOT

In this example, the show cluster-switches command was issued on a cluster root. The Switch‑IP section of the output shows the IP address of a VLANVirtual Local Area Network. In computer networking, a single Layer 2 network may be partitioned to create multiple distinct broadcast domains, which are mutually isolated so that packets can only pass between them through one or more routers; such a domain is referred to as a Virtual Local Area Network, Virtual LAN, or VLAN. on each cluster member that can currently communicate with the cluster root.

(host) [mynode] (config) #show cluster-switches

 

SWITCH-IP CLUSTER-ROLE

-----------------------------

172.21.18.18 MEMBER

172.21.18.19 MEMBER

 

Related Commands

Command

Description

control-plane-security

Configures the control plane security profile.

cluster-member-ip

Sets the controller as a control plane security cluster root, and specifies the IPsecInternet Protocol security. IPsec is a protocol suite for secure IP communications that authenticates and encrypts each IP packet in a communication session. key for a cluster member.

cluster-root-ip

Sets the controller as a control plane security cluster member, and defines the IPsecInternet Protocol security. IPsec is a protocol suite for secure IP communications that authenticates and encrypts each IP packet in a communication session. key for communication between the cluster member and the controller’s cluster root.

Command History

Release

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

License

Command Mode

All platforms

Base operating system.

Enable or Config mode on Mobility Master.

/*]]>*/