You are here: Home > CLI Commands > Just_CLI_Topics > show controller-ip

show controller-ip

show controller-ip

Description

Show the country and domain upgrade trail of the managed device.

Syntax

No parameters.

Example

The output of this command shows the IP address and VLANVirtual Local Area Network. In computer networking, a single Layer 2 network may be partitioned to create multiple distinct broadcast domains, which are mutually isolated so that packets can only pass between them through one or more routers; such a domain is referred to as a Virtual Local Area Network, Virtual LAN, or VLAN. interface ID of the managed device.

 

(host) # show controller-ip

 

Switch IP Address: 10.17.24.19

Switch IP is configured to be Vlan Interface: 1501

Switch IPv6 Address: 2001::1

Switch IPv6 address is configured to be Vlan Interface: 1501

Related Commands

Command

Description

controller-ip

Sets the IP address of the to the loopback interface address or a specific VLANVirtual Local Area Network. In computer networking, a single Layer 2 network may be partitioned to create multiple distinct broadcast domains, which are mutually isolated so that packets can only pass between them through one or more routers; such a domain is referred to as a Virtual Local Area Network, Virtual LAN, or VLAN. interface address.

Command History

Release

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

License

Command Mode

All platforms

Base operating system.

Available in Enable and Config modes on Mobility Master.

/*]]>*/