You are here: Home > CLI Commands > Just_CLI_Topics > show firewall-cp

show firewall-cp

show firewall-cp [internal]

Description

Displays the Control Path firewallFirewall is a network security system used for preventing unauthorized access to or from a private network. policies on the controller.

Syntax

No Parameters

Example

The output of this command shows the CP firewallFirewall is a network security system used for preventing unauthorized access to or from a private network. policies.

 

(host) [mynode] #show firewall-cp

 

CP firewall policies

--------------------

IP Version Source IP Source Mask Protocol Start Port End Port Permit/Deny hits contract

---------- --------- ----------- -------- ---------- -------- ----------- ---- --------

ipv4 any 6 21 21 Permit 0 test

ipv4 10.10.10.10 2.2.2.2 6 8 9 Permit 0

ipv4 2:2:2:2::2 1 1 2 Permit 0

Related Commands

Command

Description

firewall

This command configures firewallFirewall is a network security system used for preventing unauthorized access to or from a private network. options on the controller.

firewall cp-bandwidth-contract

This command configures bandwidth contract traffic rate limits to prevent denial of service attacks.

Command History

Version

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platform

License

Command Mode

All platforms

Base operating system.

Available in Enable and Config modes on Mobility Master and managed devices.

/*]]>*/