You are here: Home > CLI Commands > Just_CLI_Topics > show interface counters

show interface counters

show interface counters

Description

Displays a table of L2 interfaces counters.

Syntax

No parameters

Example

The example below shows the output of the show interface counters command.

(host) [mynode] #show interface counters

Port InOctets InUcastPkts InMcastPkts InBcastPkts

GE0/0/0 87071474 45349 590754 112566

Port OutOctets OutUcastPkts OutMcastPkts OutBcastPkts

GE0/0/0 10646801 18727 581 2

The output of this command includes the following parameters:

Parameter

Description

Port

Port number.

InOctets

Number of octets received through the port.

InUcastPkts

Number of unicast packets received through the port.

InMcastPkts

Number of multicast packets received through the port.

InBcastPkts

Number of broadcast packets received through the port.

OutOctets

Number of octets sent through the port.

OutUcastPkts

Number of unicast packets sent through the port.

OutMcastPkts

Number of multicast packets sent through the port.

OutBcastPkts

Number of broadcast packets sent through the port.

Related Commands

Command

Description

interface range

This command configures a range of GigabitEthernet interfaces on the managed device.

interface tunnel

This command configures a Layer-2 or Layer-3 GREGeneric Routing Encapsulation. GRE is an IP encapsulation protocol that is used to transport packets over a network. tunnel between a managed device and another GREGeneric Routing Encapsulation. GRE is an IP encapsulation protocol that is used to transport packets over a network.-capable device.

interface vlan

This command configures a VLANVirtual Local Area Network. In computer networking, a single Layer 2 network may be partitioned to create multiple distinct broadcast domains, which are mutually isolated so that packets can only pass between them through one or more routers; such a domain is referred to as a Virtual Local Area Network, Virtual LAN, or VLAN. interface.

interface vlan ip igmp

This command enables IGMPInternet Group Management Protocol. Communications protocol used by hosts and adjacent routers on IP networks to establish multicast group memberships. or IGMP snoopingIGMP snooping prevents multicast flooding on Layer 2 network by treating multicast traffic as broadcast traffic. Without IGMP snooping, all streams could be flooded to all ports on that VLAN. When multicast flooding occurs, end-hosts that happen to be in the same VLAN would receive all the streams only to be discarded without snooping. on this interface, or configures a VLANVirtual Local Area Network. In computer networking, a single Layer 2 network may be partitioned to create multiple distinct broadcast domains, which are mutually isolated so that packets can only pass between them through one or more routers; such a domain is referred to as a Virtual Local Area Network, Virtual LAN, or VLAN. interface for uninterrupted streaming of multicast traffic.

Command History

Release

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

License

Command Mode

All platforms

Base operating system.

Enable or Config mode on Mobility Master.

/*]]>*/