You are here: Home > CLI Commands > Just_CLI_Topics > show interface mgmt

show interface mgmt

show interface mgmt

Description

Displays information about management EthernetEthernet is a network protocol for data transmission over LAN. IP interfaces.

Syntax

No parameters

Example

The example below shows the output of show interface mgmt:

(host) [mynode] (config)# show interface mgmt

 

mgmt is up line protocol is up

Hardware is Ethernet, address is 00:0C:29:37:AB:77

The output of this command includes the following parameters:

Parameter

Description

mgmt is...

Status of the mgmt interface.

line protocol is...

Status of the line protocol on the specified port.

Hardware is...

Describes the hardware interface type.

address is...

Interface’s MACMedia Access Control. A MAC address is a unique identifier assigned to network interfaces for communications on a network. address.

Related Commands

Command

Description

interface mgmt

This command configures the out-of-bandBand refers to a specified range of frequencies of electromagnetic radiation. EthernetEthernet is a network protocol for data transmission over LAN. management port on controller.

interface range

This command configures a range of GigabitEthernet interfaces on the managed device.

interface tunnel

This command configures a Layer-2 or Layer-3 GREGeneric Routing Encapsulation. GRE is an IP encapsulation protocol that is used to transport packets over a network. tunnel between a managed device and another GREGeneric Routing Encapsulation. GRE is an IP encapsulation protocol that is used to transport packets over a network.-capable device.

interface vlan

This command configures a VLANVirtual Local Area Network. In computer networking, a single Layer 2 network may be partitioned to create multiple distinct broadcast domains, which are mutually isolated so that packets can only pass between them through one or more routers; such a domain is referred to as a Virtual Local Area Network, Virtual LAN, or VLAN. interface.

interface vlan ip igmp

This command enables IGMPInternet Group Management Protocol. Communications protocol used by hosts and adjacent routers on IP networks to establish multicast group memberships. or IGMP snoopingIGMP snooping prevents multicast flooding on Layer 2 network by treating multicast traffic as broadcast traffic. Without IGMP snooping, all streams could be flooded to all ports on that VLAN. When multicast flooding occurs, end-hosts that happen to be in the same VLAN would receive all the streams only to be discarded without snooping. on this interface, or configures a VLANVirtual Local Area Network. In computer networking, a single Layer 2 network may be partitioned to create multiple distinct broadcast domains, which are mutually isolated so that packets can only pass between them through one or more routers; such a domain is referred to as a Virtual Local Area Network, Virtual LAN, or VLAN. interface for uninterrupted streaming of multicast traffic.

Command History

Release

Modification

ArubaOS 8.0.0.0

Command Introduced.

Command Information

Platforms

License

Command Mode

All platforms

Base operating system.

Enable or config mode on Mobility Master.

/*]]>*/