You are here: Home > CLI Commands > Just_CLI_Topics > show ip health-check

show ip health-check

show ip health-check <probe-ip> <src_intf>

Description

This command displays the health-check status of the uplink interfaces of a branch office managed device.

Syntax

Parameter

Description

<probe-ip>

IP address of Mobility Master.

<src_intf>

Source interface VLANVirtual Local Area Network. In computer networking, a single Layer 2 network may be partitioned to create multiple distinct broadcast domains, which are mutually isolated so that packets can only pass between them through one or more routers; such a domain is referred to as a Virtual Local Area Network, Virtual LAN, or VLAN..

Usage Guidelines

This command should be executed from the branch office managed device.

Example

The following example displays the status of two uplinks on a branch office managed device.

(host-md) #show ip health-check

 

IP Health-Check Entries

-----------------------

Probe IP Src Interface State Probe Profile Avg RTT(ms)

-------- ------------- ------ -------------- ----------

10.10.10.254 vlan 1 UP  Default 20.4

10.10.10.254 Cellular DOWN  Default 0

The output of this command includes the following data columns.

Parameter

Description

Probe IP

IP address of Mobility Master.

Src Interface

IP address of the uplink gatewayGateway is a network node that allows traffic to flow in and out of the network. interface through which the probes were sent.

State

Shows if the uplink is in an UP or DOWN state.

Probe-Profile

A branch of managed device supports only the default IP probe profile. For information on configuring an IP probe profile, see ip probe default

Avt RTT (in ms)

The average round trip time, in milliseconds. If the round trip time is less than 1 millisecond, the average round trip time will appear as 0.

Related Commands

Command

Description

ip probe default

This command configures WANWide Area Network. WAN is a telecommunications network or computer network that extends over a large geographical distance. health-check ping-probes for measuring WANWide Area Network. WAN is a telecommunications network or computer network that extends over a large geographical distance. availability and latency on managed device uplinks.

ip probe health-check

This command configures WANWide Area Network. WAN is a telecommunications network or computer network that extends over a large geographical distance. health-check ping-probes for measuring WANWide Area Network. WAN is a telecommunications network or computer network that extends over a large geographical distance. availability and latency on managed device uplinks.

show ip probe

This command displays the settings for the WANWide Area Network. WAN is a telecommunications network or computer network that extends over a large geographical distance. health-check ping-probes.

Command History

Release

Modification

ArubaOS 8.0.0.0

Command Introduced.

Command Information

Platforms

License

Command Mode

All platforms

Base operating system.

Enable mode on Managed Device.

/*]]>*/