You are here: Home > CLI Commands > Just_CLI_Topics > show ip pppoe-info

show ip pppoe-info

show ip pppoe-info

Description

This command displays the configuration settings for PPPoEPoint-to-Point Protocol over Ethernet. PPPoE is a method of connecting to the Internet, typically used with DSL services, where the client connects to the DSL modem..

Syntax

No parameters.

Examples

The following example displays the current PPPoEPoint-to-Point Protocol over Ethernet. PPPoE is a method of connecting to the Internet, typically used with DSL services, where the client connects to the DSL modem. configuration.

(host) [mynode] #show ip pppoe-info

 

PPPoE username: rudolph123

PPPoE password: <HIDDEN>

PPPoE service name: ppp2056

PPPoE VLAN: 22

Gateway NAT: Enabled IP: 10.1.1.1

PPPoE is UP

Server IP: 9.0.0.3

Gateway IP: 9.0.0.3

Primary DNS: <NONE> Secondary DNS: <NONE>

The output of this command includes the following parameters:

Parameter

Description

PPPoE username

PAPPassword Authentication Protocol. PAP validates users by password. PAP does not encrypt passwords for transmission and is thus considered insecure. username configured on the PPPoEPoint-to-Point Protocol over Ethernet. PPPoE is a method of connecting to the Internet, typically used with DSL services, where the client connects to the DSL modem. access concentrator.

PPPoE password

If this parameter displays the word <HIDDEN>, a PAPPassword Authentication Protocol. PAP validates users by password. PAP does not encrypt passwords for transmission and is thus considered insecure. password is configured on the PPPoEPoint-to-Point Protocol over Ethernet. PPPoE is a method of connecting to the Internet, typically used with DSL services, where the client connects to the DSL modem. access concentrator. If this parameter is <NONE>, there is no PPPoEPoint-to-Point Protocol over Ethernet. PPPoE is a method of connecting to the Internet, typically used with DSL services, where the client connects to the DSL modem. password configured.

PPPoE service name

PPPoEPoint-to-Point Protocol over Ethernet. PPPoE is a method of connecting to the Internet, typically used with DSL services, where the client connects to the DSL modem. service name.

PPPoE VLAN

VLANVirtual Local Area Network. In computer networking, a single Layer 2 network may be partitioned to create multiple distinct broadcast domains, which are mutually isolated so that packets can only pass between them through one or more routers; such a domain is referred to as a Virtual Local Area Network, Virtual LAN, or VLAN. configured to use PPPoEPoint-to-Point Protocol over Ethernet. PPPoE is a method of connecting to the Internet, typically used with DSL services, where the client connects to the DSL modem. to obtain an IP address via the command interface vlan <id> ip address pppoe.

Related Commands

Command

Description

ap provisioning-profile

This command defines a provisioning profile for an AP or group of APs.

Command History

Release

Modification

ArubaOS 8.4.0.0

The output of the show ip pppoe-info command is modified to display Gateway NAT and IP parameters.

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

License

Command Mode

All platforms

Base operating system.

Enable or Config mode on Mobility Master.

/*]]>*/