You are here: Home > CLI Commands > Just_CLI_Topics > show log system

show log system

show log system{[<number>][all]}

Description

Show the controller’s system logs.

Syntax

Parameter

Description

<number>

Start displaying the log output from the specified number of lines from the end of the log.

all

Shows all the system logs for the controller.

Example

This example shows the controller’s last ten system logs.

 

(host)[node] #show log system 10

 

Mar 5 11:55:59 :316073: <DBUG> |wms| Received New AP Message: AP 00:0b:86:b5:87:c2 Status 1 Num-WM 0

Mar 5 11:55:59 :316083: <DBUG> |wms| mysql: UPDATE ap_table SET ssid='qa-abu-customerissue', current_channel='11', type='generic-ap', ibss='no', phy_type='80211g', rap_type='interfering', match_mac='00:00:00:00:00:00', power_level='255', status='up' WHERE id='71575' ;

Mar 5 11:55:59 :316029: <DBUG> |wms| Sending message to Probe: IP:10.3.49.253 Msg-Type:PROBE_RAP_TYPE AP 00:0b:86:b5:87:c2 Type:1

Mar 5 11:55:59 :316036: <DBUG> |wms| Received New STA Message: MAC 00:0b:86:b5:87:c2 Status 0

Mar 5 11:55:59 :316032: <DBUG> |wms| STA Probe: ADD Probe 00:0b:86:a2:e7:40 for STA 00:0b:86:b5:87:c2

Mar 5 11:56:00 :399814: <DBUG> |fpapps| PoE: RAN THRU ITERATION 2

Mar 5 11:56:00 :326001: <DBUG> |AP 1.1.1@10.3.49.253 sapd| AM: am_read_bss_data_stats: radio 0: pktsIn 0 pktsOut 0 bytesIn 0 bytesOut 0

Mar 5 11:56:00 :326001: <DBUG> |AP 1.1.1@10.3.49.253 sapd| AM: am_read_bss_data_stats: radio 0: pktsIn 0 pktsOut 52107 bytesIn 0 bytesOut 18143486

Mar 5 11:56:01 :326001: <DBUG> |AP 1.1.1@10.3.49.253 sapd| AM: MPPS 2722 CPPS 338 PKTS 452036609 BYTES 2062458092 INTR 334327351

Mar 5 11:56:02 :399814: <DBUG> |fpapps| PoE: Evaluating port 1/5 rv is 0 and crv is 1

state :3

Related Commands

Command

Description

logging

Use this command to specify the IP address of the remote logging server, facility, severity, and the type.

Command History

Release

Modification

ArubaOS 8.0.0.0 Command Introduced.

Command Information

Platforms

Licensing

Command Mode

All platforms

Base operating system.

Enable or Config mode on Mobility Master or managed devices.

/*]]>*/