You are here: Home > CLI Commands > Just_CLI_Topics > show neighbor devices

show neighbor-devices

show neighbor-devices

Description

Show neighbor device information

Syntax

No Parameters

Example

The command in the first example below shows that the managed device recognizes two neihbor devices.

[host] (node) # show neighbor devices

Interface objtype is 7

Capability codes: (R)Router, (B)Bridge, (A)Access Point, (P)Phone, (S)Station

(r)Repeater, (O)Other

Neighbor Devices Information

-------------------------

Local Intf Chassis ID Capability Remote Intf Expiry-Time (Secs) System

--------- ----------- ----------- ----------- ------------------ -----------

0/0/1 00:0b:86:6a:25:40 B:R 0/0/17 105 Aruba 7220

0/0/2 00:0b:86:6a:25:40 B:R 0/0/18 105 Aruba 7220

Parameter

Description

Local Intf

Slot and port number of the local interface that detected the neighbor devices.

Chassis ID

MACMedia Access Control. A MAC address is a unique identifier assigned to network interfaces for communications on a network. address of the neighbor device.

Capability

Shows the capabilities of the neighbor deviceto operate as a router, bridge, access point, phone or other network device.

Remote Intf

Slot and port number of the remote interface on the neighbor device

Expiry-time

Expiry time.

System Name

Name of the neighbor device, as supplied by the neighbor.

Command History

Release

Modification

ArubaOS 8.0.0.0 Command Introduced.

Command Information

Platforms

Licensing

Command Mode

All platforms

Base operating system.

Enable mode on managed devices. This command is not supported on Mobility Master.

/*]]>*/