You are here: Home > CLI Commands > Just_CLI_Topics > show packet-capture

show packet-capture

show packet-capture

controlpath-pcap [hex]

datapath-pcap [hex]

Description

Displays packet capture status on the controller.

Syntax

Parameter

Description

controlpath-pcap [hex]

Displays controlpath packets captured in the local-filesystem.

datapath-pcap [hex]

Displays datapath packets captured in the local-filesystem.

Example

The output of this command shows the packet capture configuration details.

(host)[mynode] #show packet-capture

Active Capture Destination

--------------------------

Destination IP 1.2.3.4

Active Capture (Controlpath)

----------------------------

Interprocess Disabled

Sysmsg Disabled

TCP Enabled Ports: 2

UDP Enabled Ports: 5

Other Enabled

Active Capture (Datapath)

-------------------------

Wifi-Client Enabled Mac: 00:0b:86:6d:47:6c Filter: Decrypted

Ipsec Enabled Peer: 10.1.1.1

(host) (config) #show packet-capture-defaults

Default Capture Destination

---------------------------

Destination Local-Filesystem

Default Capture (Controlpath)

-----------------------------

Interprocess Disabled

Sysmsg Disabled

TCP Enabled Ports: 80 8080

UDP Enabled Ports: All

Other Disabled

Default Capture (Datapath)

--------------------------

Wifi-Client Enabled Mac: 00:0b:86:6d:47:6c Filter: Encrypted

Ipsec Disabled

Related Commands

Command

Description

packet-capture

This command enables or disables packet capturing and sets packet capturing options for a single packet capture session.

packet-capture-defaults

This command enables or disables packet capturing and defines a set of default packet capturing options on the control path for debugging purposes.

ap packet-capture

These commands manage WiFi packet capture (PCAP) on Aruba APs. The WiFi packets are encapsulated in a UDPUser Datagram Protocol. UDP is a part of the TCP/IP family of protocols used for data transfer. UDP is typically used for streaming media. UDP is a stateless protocol, which means it does not acknowledge that the packets being sent have been received. header and sent to a client running a packet analyzer like Wildpacket’s Airopeek, Omnipeek, or Wireshark.

no packet-capture

This command disables packet capturing for debugging.

Command History

Release

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

Licensing

Command Mode

All platforms

Base operating system.

Config or Enable mode on Mobility Master.

/*]]>*/