You are here: Home > CLI Commands > Just_CLI_Topics > show poe

show poe

show poe [<slot/module/port>]

Description

Displays the PoEPower over Ethernet. PoE is a technology for wired Ethernet LANs to carry electric power required for the device in the data cables. The IEEE 802.3af PoE standard provides up to 15.4 W of power on each port. status of all or a specific port on the controller.

Syntax

No parameters.

Example

The output of this command shows the PoEPower over Ethernet. PoE is a technology for wired Ethernet LANs to carry electric power required for the device in the data cables. The IEEE 802.3af PoE standard provides up to 15.4 W of power on each port. status of the specified slot, module and port.

(host)[mynode] # show poe 0/0/2

 

PoE Status

----------

Port Status Voltage(mV) Current(mA) Power (mW)

---- ------ ----------- ----------- ----------

GE 0/0/2 Off N/A N/A N/A

Related Commands

Command

Description

ap enet-link-profile

This command configures an AP EthernetEthernet is a network protocol for data transmission over LAN. link profile.

Command History

 

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

Licensing

Command Mode

All platforms

Base operating system.

Config or Enable mode on Mobility Master.

/*]]>*/