You are here: Home > CLI Commands > Just_CLI_Topics > show provisioning-params

show provisioning-params

show provisioning-params

Description

Displays the list of parameters and the values used to provision the APs.

Syntax

No parameters.

Example

The output of this command shows list of all provisioning parameters and their values.

(host) [mynode]# show provisioning-params

AP provisioning

---------------

Parameter Value

--------- -----

AP Name N/A

AP Group default

Location name N/A

SNMP sysLocation N/A

Master N/A

Gateway N/A

IPv6 Gateway N/A

Netmask N/A

IP Addr N/A

IPv6 Addr N/A

IPv6 Prefix 64

DNS IP N/A

DNS IPv6 N/A

Domain Name N/A

Server Name N/A

Server IP N/A

Antenna gain for 802.11a N/A

Antenna gain for 802.11g N/A

Use external antenna No

Antenna for 802.11a both

Antenna for 802.11g both

PKCS12 PASSPHRASE N/A

Single chain mode for Radio 0 0

Single chain mode for Radio 1 0

External antenna polarization for 5GHz Radio 0

External antenna polarization for 2.4GHz Radio 0

TrustAnchor N/A

IKE PSK N/A

ikepsk-hex-based No

PAP User Name N/A

PAP Password N/A

PPPOE User Name N/A

PPPOE Password N/A

PPPOE Service Name N/A

PPPOE CHAP Secret N/A

USB User Name N/A

USB Password N/A

USB Device Type none

USB CSR-Key Storage No

USB Device Identifier N/A

USB Dial String N/A

USB Initialization String N/A

USB TTY device data path N/A

USB TTY device control path N/A

USB modeswitch parameters N/A

Uplink VLAN 0

Remote AP No

OCSP Default N/A

certificate DN N/A

Link Priority Ethernet 0

Link Priority Cellular 0

Cellular modem network preference auto

USB power mode auto

AP POE Power optimization false

AP2xx prestandard POE detection Disabled

Mesh Role none

Installation default

Latitude N/A

Longitude N/A

Altitude N/A

Antenna bearing for 802.11a N/A

Antenna bearing for 802.11g N/A

Antenna tilt angle for 802.11a N/A

Antenna tilt angle for 802.11g N/A

Username of AP so that AP can authenticate to 802.1x using PEAP N/A

Password of AP so that AP can authenticate to 802.1x using PEAP N/A

Enable AP to 802.1x using EAP-TLS Disabled

Enable AP to use factory certificates when doing 802.1x EAP-TLS Disabled

AP dot1x EAP-TLS username suffix Disabled

AP dot1x EAP-TLS username suffix domain aruba.ap

Mesh SAE sae-disable

Related Commands

Command

Description

ap provisioning-profile

This command defines a provisioning profile for an AP or group of APs.

provision-ap

This command provisions or reprovisions an AP.

Command History

Release

Modification

ArubaOS 8.4.0.0

The output of the show provisioning-params command was modified to include the following parameters:

AP dot1x EAP-TLS username suffix

AP dot1x EAP-TLS username suffix domain

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

License

Command Mode

All platforms

Base operating system.

Config or Enable mode on Mobility Master.

/*]]>*/