You are here: Home > CLI Commands > Just_CLI_Topics > show references ap-lacp-striping-ip

show references ap-lacp-striping-ip

show references

ap-lacp-striping-ip

[page <page>] [start <start>]

Description

This command shows the references to the AP LACPLink Aggregation Control Protocol. LACP is used for the collective handling of multiple physical ports that can be seen as a single channel for network traffic purposes. LMSLocal Management Switch. In multi-controller networks, each controller acts as an LMS and terminates user traffic from the APs, processes, and forwards the traffic to the wired network. map information.

Syntax

Parameter

Description

ap-lacp-striping-ip

Shows references to AP LACPLink Aggregation Control Protocol. LACP is used for the collective handling of multiple physical ports that can be seen as a single channel for network traffic purposes. LMSLocal Management Switch. In multi-controller networks, each controller acts as an LMS and terminates user traffic from the APs, processes, and forwards the traffic to the wired network. map information.

Example

The following is an example for execution of the show references ap-lacp-striping-ip command:

(host) [mynode] #show references ap-lacp-striping-ip

Related Commands

Command

Description

ap-lacp-striping-ip

Configures the AP LACPLink Aggregation Control Protocol. LACP is used for the collective handling of multiple physical ports that can be seen as a single channel for network traffic purposes. LMSLocal Management Switch. In multi-controller networks, each controller acts as an LMS and terminates user traffic from the APs, processes, and forwards the traffic to the wired network. map information.

Command History

Release

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

License

Command Mode

All platforms

Base operating system.

Config or Enable mode on Mobility Master.

/*]]>*/