You are here: Home > CLI Commands > Just_CLI_Topics > show rf ht-radio-profile

show rf ht-radio-profile

show rf ht-radio-profile [<profile>]


Show a High-throughput Radio profile.





Name of a High-throughput Radio profile.

Usage Guidelines

Issue this command without the <profile>parameter to display the entire High-throughput Radio profile list, including profile status and the number of references to each profile. Include a profile name to display detailed configuration information for that profile.


The example below shows that the controller has five configured High-throughput Radio profiles. The References column lists the number of other profiles with references to the High-throughput Radio profile, and the Profile Status column indicates whether the profile is predefined and editable, and if that predefined profile has been changed from its default settings. User-defined profiles will not have an entry in the Profile Status column.

(host)[mynode]# show rf ht-radio-profile

High-throughput radio profile List


Name References Profile Status

---- ---------- --------------

default 0

default-a 8 Predefined (editable)

default-g 3 Predefined (changed)

legacystation 1

test 1



This example displays the configuration settings for the predefined profile default-a.

(host) #show rf ht-radio-profile default-a

High-throughput radio profile "default-a" (Predefined (editable))


Parameter Value

--------- -----

40 MHz intolerance Disabled

Honor 40 MHz intolerance Enabled

Diversity spreading workaround Disabled

The output of this command includes the following parameters:



40 MHzMegahertz intolerance

Shows whether or not APs using this radio profile will advertise intolerance of 40 MHzMegahertz operation. By default, 40 MHzMegahertz operation is allowed.

Honor 40 MHzMegahertz intolerance

If this parameter is enabled, the radio will stop using the 40 MHzMegahertz channels if the 40 MHzMegahertz intolerance indication is received from another AP or station.

Diversity Spreading Workaround

When this feature is enabled, all legacy transmissions will be sent using a single antenna. This enables interoperability for legacy or high-throughput stations that cannot decode 802.11n cyclic shift diversity data.

This feature is disabled by default and should be kept disabled unless necessary.

Related Commands

Related Command


rf ht-radio-profile

This command configures high-throughput AP radio settings. High-throughput features use the IEEEInstitute of Electrical and Electronics Engineers. 802.11n802.11n is a wireless networking standard to improve network throughput over the two previous standards, 802.11a and 802.11g. With 802.11n, there will be a significant increase in the maximum raw data rate from 54 Mbps to 600 Mbps with the use of four spatial streams at a channel width of 40 MHz. standard.

Command History




Command introduced.

Command Information



Command Mode

All platforms

Base operating system.

Config mode on Mobility Master.