You are here: Home > CLI Commands > Just_CLI_Topics > show rft result

show rft result

show rft result all|{trans-id <trans-id>}

Description

Show the results of an RFRadio Frequency. RF refers to the electromagnetic wave frequencies within a range of 3 kHz to 300 GHz, including the frequencies used for communications or Radar signals. test.

Syntax

Parameter

Description

all

Show the most recent test result for each test type (antenna-connectivity, link-quality or raw).

trans-id <trans-id>

Each RFRadio Frequency. RF refers to the electromagnetic wave frequencies within a range of 3 kHz to 300 GHz, including the frequencies used for communications or Radar signals. test is assigned a transaction ID. Include the trans-id <trans-id> parameters to show the test result for a specific transaction ID.

Usage guidelines

The rft command is used for RFRadio Frequency. RF refers to the electromagnetic wave frequencies within a range of 3 kHz to 300 GHz, including the frequencies used for communications or Radar signals. troubleshooting, and should only be used under the supervision of Aruba technical support.

Related Commands

Command

Description

show rft transactions

Shows the most recent transaction IDs for each test type.

Command History

Release

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

Licensing

Command Mode

All platforms

Base operating system.

Available in Enable and Config modes on Mobility Master and managed devices.

/*]]>*/