You are here: Home > CLI Commands > Just_CLI_Topics > show tunnel-group

show tunnel-group

show tunnel-group <tunnel-group-name>

Description

Displays the operational status of the tunnel-groups configured on the controller.

Syntax

Parameter

Description

<tunnel-group-name>

Displays the operational status of the specified tunnel-group.

Example

The output of this command shows the status of the configured tunnel-groups:

(host) #show tunnel-group

 

Tunnel-Group Table Entries

--------------------------

Tunnel Group Type Tunnel Group Id Preemptive Failover Active Tunnel Id Tunnel Members

------------ ---- --------------- -------------------- ---------------- --------------

tgroup1 L3 16385 enabled 10 10 20

tgroup2 L2 16387 enabled 10 10 20 40

The output of the following command shows the status of the specified tunnel-group:

(host) #show tunnel-group tgroup1

 

Tunnel-Group Table Entries

--------------------------

Tunnel Group Type Tunnel Group Id Preemptive Failover Active Tunnel Id Tunnel Members

------------ ---- --------------- -------------------- ---------------- --------------

tgroup1 L3 16385 enabled 10 10 20

The output of the following command shows the datapath Tunnel-Group table entries:

(host) #show datapath tunnel-group

 

Datapath Tunnel-Group Table Entries

-----------------------------------

Tunnel-Group Active Tunnel Members

------------ ------------- ---------

16385 10 10 20

Related Commands

Command

Description

tunnel-group

This command creates a tunnel-group to group a set of tunnels.

Command History

Release

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

Licensing

Command Mode

All platforms

Base operating system.

Available in Enable and Config modes on Mobility Master and managed devices.

/*]]>*/