You are here: Home > CLI Commands > Just_CLI_Topics > show ipv6 route

show ipv6 route

show ipv6 route [counters | static]

Description

Displays the IPv6 routing table.

Syntax

Command

Description

counters

Displays the number of routes present, categorized by type.

static

Include this optional parameter to display only static IPv6 routes.

Usage Guidelines

This command displays static IPv6 routes configured on the managed device via the ipv6 route command. Use the ipv6 default-gateway command to set the default gatewayGateway is a network node that allows traffic to flow in and out of the network. to the IPv6 address of the interface on the upstream router or switch to which you connect the managed device.

Examples

The examples below show the ipv6 address of routers and the VLANsVirtual Local Area Network. In computer networking, a single Layer 2 network may be partitioned to create multiple distinct broadcast domains, which are mutually isolated so that packets can only pass between them through one or more routers; such a domain is referred to as a Virtual Local Area Network, Virtual LAN, or VLAN. to which they are connected.

(host) [mynode] #show ipv6 route

Codes: C - connected, O - OSPF, R - RIP, S - static

M - mgmt, U - route usable, * - candidate default

 

Gateway of last resort is 2001::3 to network ::/128 at cost 1

S* ::/0 [1/0] via 2001::3*

C 2001::/64 is directly connected, VLAN1

C 2010:abcd:1234:dead::/64 is directly connected, VLAN10

 

(host) [mynode] #show ipv6 route static

Gateway of last resort is 2001::3 to network ::/128 at cost 1

S* ::/0 [1/0] via 2001::3*

Related Commands

Command

Description

ipv6 route

This command configures static IPv6 routes on the managed device.

Command History

Release

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

License

Command Mode

All platforms

Base operating system.

Available in Config or Enable mode on Mobility Master.

/*]]>*/