You are here: Home > CLI Commands > Just_CLI_Topics > show wlan bcn-rpt-req-profile

show wlan bcn-rpt-req-profile

show wlan bcn-rpt-req-profile <profile-name>

Description

Shows configuration and other information about the parameters for the Beacon Report Request frames.

Syntax

Parameter

Description

<profile>

Name of a WLAN beacon report request profile.

Usage Guidelines

Issue this command without the <profile> parameter to display the entire Beacon Report Request profile list, including profile status and the number of references to each profile. Include a profile name to display detailed configuration information for that profile.

For this profile to take effect, the 802.11K feature needs to be enabled.

Examples

(host) #show wlan bcn-rpt-req-profile

Beacon Report Request Profile List

----------------------------------

Name References Profile Status

---- ---------- --------------

default 1

test 0

Total:2

(host) #

(host) #show wlan bcn-rpt-req-profile default

 

Beacon Report Request Profile "default"

---------------------------------------

Parameter Value

--------- -----

Interface 1

Regulatory Class 12

Channel 9

Randomization Interval 100

Measurement Duration 100

Measurement Mode for Beacon Reports active-all-ch

Reporting Condition 2

ESSID Name aruba-ap

Reporting Detail Disabled

Measurement Duration Mandatory Disabled

Request Information values 0/21/22


The output of this command includes the following parameters:

Parameter

Description

Interface

Specifies the Radio interface for transmitting the Beacon Report Request frame. It can have a value of either 0 or 1.

Regulatory Class

Specifies the Regulatory Class field in the Beacon Report Request frame.

Channel

Specifies the Channel field in the Beacon Report Request frame.

Randomization Interval

Specifies the Randomization Interval field in the Beacon Report Request frame. The Randomization Interval is used to specify the desired maximum random delay in the measurement start time. It is expressed in units of TUs (Time Units).

Measurement Duration

Specifies the Measurement Duration field in the Beacon Report Request frame. The Measurement Duration is set to the duration of the requested measurement. It is expressed in units of TUs.

Measuremement Mode for Beacon Reports

Specifies the mode used for the measurement. The valid measurement modes are:

active-all-ch

active-ch-rpt

beacon-table

passive

Reporting Condition

Specifies the value for the "Reporting Condition" field in the Beacon Reporting Information sub-element present in the Beacon Report Request frame.

ESSID Name

Specifies the value for the "SSIDService Set Identifier. SSID is a name given to a WLAN and is used by the client to access a WLAN network." field in the Beacon Report Request frame.

Reporting Detail

Indicates the value for the "Detail" field in the Reporting Detail sub-element present in the Beacon Report Request frame.

Measurement Duration Mandatory

Specifies the "Duration Mandatory" bit of the Measurement Request Mode field of the Beacon Report Request frame.

Request Information values

Indicates the contents of the Request Information IE that could be present in the Beacon Report Request frame. The Request Information IE is present for all Measurement Modes except the 'Beacon Table' mode. It consists of a list of Element IDs that should be included by the client in the response frame.

Related Commands

Command

Description

wlan bcn-rpt-req-profile

Configures a Beacon Report Request Profile to provide the parameters for the Beacon Report Request frames.

Command History

Version

Modification

ArubaOS 8.0.0.0

Command introduced.

Command Information

Platforms

License

Command Mode

All platforms

Base operating system.

Enable and Config mode on Mobility Master.

/*]]>*/